Zanussi recommends the use of Finish dish-
Spray arm (1)washer detergent and Rinse Aid.
It is important to keep all the holes in the spray arm clear.
A clogged hole can seriously affect washing efŢciency.
If the spray arm needs cleaning, unscrew the nut anti-Water softener (6)
clockwise, remove the washer and lift off the spray arm.This dishwasher is equipped with a water softener for hard
Clear the holes and shake out any food remnants.water. The lime in hard water causes white deposits to
occur on dishes and to the interior of the dishwasher.
Coarse strainer/microŢlter (2)To prevent this, the water has to pass through a special
container where the hardness is removed.
The purpose of the coarse strainer is to catch large objectsSince the water softener uses coarse dishwasher salt,
such as toothpicks and pieces of eggshell. Make sure
that the strainer is always clean. Turn the coarse straineryou will have to reŢll the salt container after a certain
anti-clockwise. Lift it out and rinse it under running waternumber of dishwasher cycles.
whenever necessary.It is extremely important, that the salt container
is Ţlled up with the coarse dishwasher salt before
Fine Ţlter (3)using the dishwasher for the Ţrst time.
It is just as important to keep this Ţlter clean. A dirty orThe indicator light on the control panel is lit when the
clogged Ţlter will always impair washing efŢciency. container requires reŢlling.
The Ţne Ţlter can easily be lifted out for cleaning when
you have removed the coarse strainer.1. Unscrew the Ţller cap to the salt container anti-
clockwise.
Detergent dispenser (4)2. Fill the salt container with water (only the Ţrst
Open the lid to the dispenser by pressing the lid catchtime).
towards the compartment. Consult the instructions on the3. Fill the container with dishwasher salt, using the
detergent packet, Ţll the compartment accordingly andfunnel supplied.
close the lid. Pre-wash detergent is poured into the smaller4. Remove the funnel and wipe off any spillage
compartment to the left when needed. This detergent is
active allready at pre-rinsing. Make sure that there is noaround the Ţller opening.
items that prevents the lid from opening.5. Screw the Ţller cap back properly in place.
Only use detergents specially designed for dish-The water softener is now ready for the Ţrst load of dishes.
washers.Always make sure that there is coarse dishwasher salt in
the container, which holds about 1 litre.
Rinse aid dispenser (5)To adjust the water softener, see page 7.
Use of rinse aid will result in cleaner and faster drying ofOnly use special salt for dishwashing machines,
the load, since it helps water and soil to run off. ordinary domestic salt, especially table salt, can
Too much rinse aid may result in streakiness, too littledamage the water softener.
may cause white spots. The dispenser holds about 150 ml.
This is enough for approx. 60 wash cycles, depending
on the dosage setting. Adjust the dosage setting according
to the hardness of the water.
You can set the dosage between 1 - 6, the appli-
ance is factory set to 1.
Begin at the lowest dosage setting and increase
if necessary by turning the setting arrow with e.g.
the handle of a spoon.
The indicator light on the control panel is lit when the
dispenser requires reŢlling.
1. Open the lid to the dispenser by pressing the lid
catch towards the compartment and lift the lid.
2. Fill up with rinse aid; do not overŢll.
3. Wipe off any spillage carefully to prevent excessive
foaming during the next wash programme.
4. Close the lid and press until it locks again.
Do not Ţll the rinse aid dispenser with liquid
detergent.
- 5 - |
ACEC
ZANUSSI
