DCR600
DCR600 Front Panel Controls
ö
o
ô
ó
o
n
�
i
î
DTSMUTEAUTO TUNED STMEMORY PRESETLO0C 0RO
DOLBY DSLEEPOO
PCM
MP3LSOLFERSO
OPTICAL 1 2COAXIAL1 2 3ANALOGOVMAx NF5.1 LOGIC 7 CMO
DIGITALPRO LOGIC3-STEREO5 CH STEREO HALL 1 THEATERNIGHT
(
*
1
&
2
34567891)!@#$%^
1 Main Power Switch: Press this button toof headphones. Be certain that the headphonesare not always available. (See page 52 for
apply power to the DCR600. When the switchhave a standard 1/4" stereo phone plug. Notemore information about surround modes.)
is pressed in, the unit is placed in a Standbythat the main room speakers will automatically
8 Tuning Selector: Press the left side of the
mode, as indicated by the amber Powerbe turned off when the headphone jack is in use.
button to tune lower-frequency stations and
Indicator 3 surrounding the System Power
Control 2. This button MUST be pressed in5 Selector Buttons: When you are estab-the right side of the button to tune higher-
to operate the unit. To turn the unit off andlishing the DCR600Os configuration settings,frequency stations. When a station with a strong
use these buttons to select from the choicessignal is reached, the TUNED indicator U will
prevent the use of the remote control, this
available, as shown in the Main Informationbe illuminated in the Main Information
switch should be pressed until it pops out from
Display o.Display o.
the front panel so that the word OOFF� may be
read at the top of the switch.
6 Tone Mode: Pressing this button enablesTo tune manually, tap the button lightly and
or disables the Bass and Treble tone controls.note that the tuner will step up one frequency
NOTE:
When the button is pressed so that the wordsincrement per button press. When the button is
This switch is normally left in the OON� position.
TONE IN appear in the Main Informationheld for a few seconds you will note that the
2 System Power Control: When the MainDisplay o, the settings of the Bass & andunit will quickly search the frequency band.
Power Switch 1 is OON,� press this buttonTreble ( controls may be used to adjust theRelease it once the fast tuning starts; the tuner
to turn on the DCR600; press it again to turnoutput signals. When the button is pressed sowill automatically scan for the next station
the unit off. Note that the Power Indicatorthat the words TONE OUT appear in the Mainwith an acceptable signal and then stop.
3 in the center of the switch will turn greenInformation Display o, the output signal
when the unit is on.will be Oflat,� without any bass or treble alter-9 Tuner Band Selector: Pressing this button
will automatically switch the DCR600 to the
ation, no matter how the actual Bass and
3 Power Indicator: This LED will be illumi-Treble &( controls are adjusted.Tuner mode. Pressing it again will switch
nated in amber when the unit is in the Standbybetween the AM and FM frequency bands.
mode to signal that the unit is ready to be7 Surround Mode Selector: Press this but-
turned on. When the unit is in operation, theton to change the surround mode by scrolling) Preset Stations Selector: Press this
button to scroll up or down through the list or
indicator will turn green.through the list of available modes. Note that
depending on the type of input, some modesstations that have been entered into the preset
4 Headphone Jack: This jack may be usedmemory.
to listen to the DCR600Os output through a pair
8 |
ACEC
JBL
