DCR-DVD100/DVD100E
SECTION 1COVERCOVER
SERVICE NOTE
1-1. SERVICE NOTE
1.POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the reer is shut ofgulated pof so wer supply (8.4V), the pow
that the unit cannot operate.
This following two methods are available to prevent this. Take note of which to use during repairs.
Method 1.
Use the AC power adaptor (AC-L15, AC-VQ800 etc.).
Method 2.
Connect the servicing remote commander RM-95 (J-6082-053-B) to the LANC jack, and set the commander switch to the OADJ� side.
2.TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
1 Refer to page 2-2 to remove the front panel assembly.
2 Refer to page 2-3 to remove the cabinet (R) assembly.
3 Refer to page 2-10 to remove the battery panel section.
4 Refer to page 2-11 to remove the EVF block.
5 Remove the VC-307 board.
6 Refer to page 2-15 to remove the lens block and the accessory shoe.
7 While pushing the porA in the dirtion ection of the arrow, push the OPEN switch in the direction of the arrow and open the disc cover.
Open switch
Plunger
A
MD-097 board
3.NOTES ON HANDLING THE OPTICAL PICK-UP4.PRECAUTION FOR CHECKING EMISSION OF
The laser diode may suffer electrostatic breakdown because of theLASER DIODE
potential difference generated by the charged electrostatic loadLaser light of the equipment is focused by the object lens in the, etc.
on clothing and the human body.optical pick-up so that the light focuses on the reflection surface of
During repair, pay attention to electrostatic breakdothe discwn and also use. Therefore, be sure to keep your eyes more then 30 cm
the procedure in the printed matter which is included in the repairapart from the object lens when you check the emission of laser
parts.diode.
The flexible board is easily damaged and should be handled with
care.
1-1 |
ACEC
SONY
