4. Flange Back Adjustment
(Using Minipattern Box or Flange Back Adjustment Jig)Preparations for the flange back adjustment jig:
The inner focus lens flange back adjustment is carried out1) Install the flange back adjustment jig so that the distance
automatically. In whichever case, the focus will be debetween it and the front of the lens of the camcorder is lessviated during
auto focusing/manual focusing.than 3cm.
2) Make the height of the flange back adjustment jig and the
SubjectFlange back adjustment jig
Or minipattern box (Siemens starcamcorder equal.
chart with ND filter (Note1))3) Adjust the illumination intensity to the chart of the flange back
adjustment jig. (350 ? 50 lux)
Measuring Instrument Adjustment remote commander
4) Check that at both the zoom TELE end and WIDE end, the
Adjustment PageFcenter of the chart and center of the monitor TV screen coincide.
Adjustment Address44 to 54
Specified ValueData of page: F, adO00�dr toess: 53 is Below 3 cm
Flange back adjustment jig
O09�.
Data of page: 6, address: 0C is O00�.
Note1: Dark Siemens star chart.Camera
Note2: This adjustment should be carried out upon completion of OHALL
Adjustment�.
Note3: Make the lens horizontal and perform this adjustment.
Note4: The data of page: 0, address: 10 must be O00�.
Note5: Check that the data of page: 6, addrO00�. If not, turn ofess: 02 is f
the power and turn on again.Fig. 6-1-8.
Switch setting:
Adjusting method:
1) POWER....................................................... CAMERA-TAPE
Order Page Address DataProcedure
Preparations:100101Set the data.
1) The minipattern box is installed as shown in the follo26wing4801Set the data.
figure.360113Set the data, and press PAUSE
Note: The attachment lenses are not used.
button.
2) Install the minipattern box so that the distance between it and
the front of the lens of the camcorder is less than 3cm.460127Set the data, and press PAUSE
3) Make the height of the minipattern box and the camcorder equal.button.
4) Check that the output voltage of the regulated po5 wer supply is602Check that the data changes to
the specified voltage.O01�. (Note6)
5) Check that at both the zoom lens TELE end and WIDE end,
660CCheck that the data is O00�.
the center of the Siemens star chart and center of the exposure
6F53Check that the data is O00� to
screen coincide.
O09�.
Specified voltage:
Note6: The adjustment data will be automatically input to page: F, address:
The specified voltage varies according to the minipattern box, so
44 to 54.
adjust the power supply output voltage to the specified voltage
written on the sheet which is supplied with the minipattern box.Processing after Completing Adjustments:
Order Page Address DataProcedureBelow 3 cm
164800Set the data.
260100Set the data, and press PAUSEMinipattern box
button.
Camcorder
360125Set the data, and press PAUSE
button.
Camera
table460100Set the data, and press PAUSE
button.
Regulated power supply
Output voltage : Specified voltage ?0.01Vdc500100Set the data.
Output current : more than 3.5A6Perform OFlange Back Check�.
Red (+)
Black (�)
Yellow (SENS +)
White (SENS �)Need not connected
Black (GND)
Fig. 6-1-7.
DCR-PC53E/PC55/PC55E
6-22 |
ACEC
SONY
