DCR-TRV255E/TRV260/TRV265/TRV265E
SECTION 1
SERVICE NOTE
1-1. NOTE FOR REPAIR
Make sure that the flat cable and flexible board are not crWhen remoacked ofve a connector, donOt pull at wire of connector.
bent at the terminal.It is possible that a wire is snapped.
Do not insert the cable insufficiently nor crookedly.
When installing a connector, donOt press down at wire of connector.
It is possible that a wire is snapped.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
1-2. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the reer is shut ofgulated pof so wer supply (8.4V), the pow
that the unit cannot operate.
The following method is available to prevent this.
Method 1.
Use the AC power adaptor (AC-L10, AC-VQ800 etc.).
1-1 |
ACEC
SONY
