b) Setting electronicallyFilling with salt
(The dishwasher must be switched off)
Only use salt specifically designed for use in
The dishwasher is factory set at level 5.
dishwashers.
All other types of salt not specifically designed for use in
1.Press the On/Off push button. The On/Off indicator light a dishwasher, especially table salt, will damage the water
illuminates (setting mode).softener.
If a programme push button indicator light is on, this means Only fill with salt just before starting one of the complete
that a washing programme has been set. The programme washing programmes.
must be cancelled: press simultaneously the function push This will prevent any grains of salt or salty water, which
buttons 2and 3for about 2 seconds. may have been spilt, remaining on the bottom of the
All the indicator lights will turn off (except for the On/Off machine for any period of time, which may cause
indicator light and eventually salt and rinse aid indicator corrosion.
lights) indicating that the setted programme has been
cancelled and the machine is now in setting mode.
To fill:
2.Press simultaneously function push buttons 2 and 3, until
1.Open the door, remove the lower basket and unscrew the
the indicator lights of the function push buttons 1, 2 and 3
cap of the salt container by turning it anticlockwise.
start flashing.
2.Pour 1 litre of water inside the container (this is necessary
3.Press the function push button 1, the indicator lights of only before filling with salt for the first time).
function push buttons 2 and 3 turn off while the indicator
3.Using the funnel provided,
light of the push button 1 goes on flashing, at the same time
pour in the salt until the SALE
the indicator light End of programmestarts to flash.ZOUT
container is full.SALT
The current level is indicated by the number of flashes of SALZ
SEL
the indicator light End of programme (see chart).4.Replace the cap making
Example:5 flashes = level 5sure that there is no trace
of salt on the screw
4.To change the level, press push button 1. Each time the thread or on the gasket.
push button is pressed the level changes. (For the selection
5.Screw on the cap tightly
of the new level see the chart).
turning it clockwise until it
Examples:SR14
stops with a click.
if the current level is 5, by pressing push button 1 once,
level 6 is selected.
if the current level is 10, by pressing push button 1 once,
level 1 is selected.The salt container will require topping up periodically. You are
reminded of this by the salt indicator light on the control panel
5.To memorise the operation, switch off the dishwasher by which comes on when the salt has finished.
pressing the On/Off push button or wait about 60 seconds
The salt indicator light on the control panel can remain
after which the dishwasher will automatically return to
illuminated for 2-6 hours after the salt has been
setting mode.
replenished, assuming the dishwasher remains switched
on. If you are using salts that take longer to dissolve then
this can take longer. The function of the machine is not
affected.
Do not worry if water over flows from the unit when filling with
salt, this is quite normal.
8 |
ACEC
ZANUSSI
