Before use
Before using your dishwasher for the
first time:
1. Ensure that the electrical and water connections
comply with the installation instructions
2. Remove all packaging from inside the appliance
3. Set the water softener
4. Pour 1 litre of water inside the salt container and
then fill with salt
5. Fill the rinse aid dispenser.
Setting the water softener
The dishwasher is equipped with a water softener
designed to remove minerals and salts from the
water supply, which would have a detrimental or
adverse effect on the operation of the appliance.
The higher the content of these salts, the harder
your water is.
Water hardness is measured in equivalent scales,
Water hardness
Clarke degrees, French degrees and PPM (parts per
Million).Level ClarkeFrenchPPMUse of
degrees degrees (Parts per salt
(°TH)Million)
The softener should be adjusted according to the
hardness of the water in your area. Your local W1 ater< 6< 8< 80NO
Authority can advise you on the hardness of the
26 - 21 8 - 30 81 - 300 YES
water in your area.
322 - 35 31 - 50 301 - 500 YES
The dishwasher is factory set at level 3.436 - 49 51 - 70 501 - 700 YES
550 - 63 71 - 90 701 - 900 YES
If this level is not suitable for your area the softener
should be adjusted.
To select a different level be sure that
the dishwasher is off and then proceed
as follows:
1. Press INTENSIVE SID 80and NORMAL
programme push buttons simultaneously.
2. While keeping the programme push buttons
INTENSIVE SID 80and NORMAL pressed
switch on the dishwasher by pressing the
ON-OFF push button.
The ON-OFF indicator light comes on.
SO390
At the same time, the indicator lights of the
INTENSIVE SID 80and NORMAL push buttons
start flashing.
6 |
ACEC
ZANUSSI
