Operating sequence
1. Check the filters The setting of the programme is
Ensure they are clean and properly positioned possible:
(see "Maintenance and cleaning").
With the door open,in this case the selected
programme and eventual options will start
automatically 5 seconds after the closing of the
door.
2. Press the ON-OFF push With the door closed,in this case the
buttonselected programme and eventual options will
start automatically 5 seconds after the last
The ON-OFF indicator light will come on and pressure of a push button.
in the digital display appear three horizontal
lines (---).
7a. Setting and starting the
3. Check that there is rinse aid programme without delay start
and salt Press the push button corresponding to the
The corresponding indicator lights will required programme: in the digital display will
appear the time duration in minutes of the
illuminate if refilling is necessary.programme and the phase indicator lights for
that programme will illuminate.
Select, if required, the HALF LOAD option.
The corresponding indicator light will illuminate
4. Load the dishes and the duration of the programme in the digital
Remove any scraps of food. display will be confirmed.
Pull the lower basket out and arrange the If the setting has been made with the door
saucepans, plates and cutlery in it. open,close the door and the programme will
Pull the upper basket out and arrange the start automatically after 5 seconds.
plates, saucers, glasses and cups etc. in it. Until the door remains opened it is possible to
change the setting.
Slide the baskets back into the machine.
If the setting has been made with the door
closed,the programme will start automatically
5 seconds after the last pressure of a push
button.
5. Ensure that the spray arms
The start of the programme will be confirmed
can rotate freely. by an audible signal, the phase indicator lights
will turn off except for the phase under way.
The duration of the programme visible in the
digital display will start to decrease from minute
6. Measure out detergent to minute.
Add the required amount of detergent into the
dispenser according to the recommended
quantity given in the Washing programmes
chart. 7b. Setting and starting the
Important!programme with delay start
If the half load option is selected Once a programme and required options
remember to reduce the quantity of have been selected (see point 7a) to set the
detergent.delay start proceed as follows:
Close the detergent dispenser lid.Press theDELAY push button, in the digital
display will appear h 1.
16 |
ACEC
ZANUSSI
