Before Using This Product
Note:
Resetting the microprocessorY The red lead (ACC) of this product should be con-
nected to a terminal coupled with ignition switch ON
The microprocessor must be reset under the
following conditions:or OFF operations. If this is not done, the vehicle
battery may be drained.
When using this product for the first time after
installation.Y When the source is off, you can check the location
of O5� and O6� by turnig on the feature demo.
When the machine fails to operate properly.
When strange (incorrect) messages appear on
the display.
Y To reset the microprocessor, press
RESET on the head unit with a pen tip or
other pointed instrument.
About basic displays
This product is equipped with two forms of
basic display. You can select the desired dis-
play.
FORM 1
About the demo mode
This product features two demonstration
modes. One is the reverse mode and the other
is the feature demo mode.
Reverse modeFORM 2
If you do not carry out an operation within about
30 seconds, screen indications will start to
reverse, and then continue reversing every 10
seconds. Pressing the button 5 when power to
this product is switched off while the ignition
switch is set to ACC or ON cancels the reverse
Note:
mode. Press the button 5 again to start the
reverse mode.Y For details, refer to OChanging the display form� on
page 49.
Feature demo
The feature demo automatically starts when
power to this product is switched off while the
ignition switch is set to ACC or ON. Pressing
the button 6 during feature demo operation can-
cels the feature demo mode. Press the button 6
again to start the feature demo mode.
Remember that if the feature demo continues
operating when the car engine is switched OFF,
it may drain battery power.
5 |
ACEC
PIONEER
