Installation and Connections
Before installing or connecting the unit, please
read the following and pages 2 and 3 of thisDO NOT USE BOLTS OR NUTS IN THE BRAKE OR
STEERING SYSTEMS TO MAKE GROUND
manual thoroughly for proper use.
CONNECTIONS.
Bolts or nuts used for the brake or steering systems (or
Warningany other safety-related system), or tanks should NEVER
DO NOT DISASSEMBLE OR ALTER.be used for installations or ground connections. Using
such parts could disable control of the vehicle and cause
Doing so may result in an accident, fire or electric shock.fire etc.
KEEP SMALL OBJECTS SUCH AS BATTERY OUT OFMAKE THE CORRECT CONNECTIONS.
THE REACH OF CHILDREN.Failure to make the proper connections may result in fire
Swallowing them may result in serious injuryor product damage.. If
swallowed, consult a physician immediately.
DO NOT BLOCK VENTS OR RADIATOR PANELS.
USE THE CORRECT AMPERE RATING WHENDoing so may cause heat to build up inside and may result
REPLACING FUSES.in fire.
Failure to do so may result in fire or electric shock.
USE ONLY IN CARS WITH A 12 VOLT NEGATIVECaution
GROUND.
(Check with your dealer if you are not sure.) Failure to doUSE SPECIFIED ACCESSORY PARTS AND INSTALL
so may result in fire, etc.THEM SECURELY.
Be sure to use only the specified accessory parts. Use of
BEFORE WIRING, DISCONNECT THE CABLE FROMother than designated parts may damage this unit
THE NEGATIVE BATTERY TERMINAL.internally or may not securely install the unit in place.
Failure to do so may result in electric shock or injury dueThis may cause parts to become loose resulting in hazards
or product failure.
to electrical shorts.
DO NOT SPLICE INTO ELECTRICAL CABLES.DO NOT INSTALL IN LOCATIONS WITH HIGH
Never cut away cable insulation to supply power to otherMOISTURE OR DUST.
equipment. Doing so will exceed the current carryingAvoid installing the unit in locations with high incidence
capacity of the wire and result in fire or electric shock.of moisture or dust. Moisture or dust that penetrates into
this unit may result in product failure.
DO NOT ALLOW CABLES TO BECOME ENTANGLED
HAVE THE WIRING AND INSTALLATION DONE BY
IN SURROUNDING OBJECTS.
Arrange wiring and cables in compliance with the manualEXPERTS.
to prevent obstructions when driving. Cables or wiringThe wiring and installation of this unit requires special
that obstruct or hang up on places such as the steeringtechnical skill and experience. To ensure safety, always
wheel, gear lever, brake pedals, etc. can be extremelycontact the dealer where you purchased this product to
hazardous.have the work done.
DO NOT DAMAGE PIPE OR WIRING WHENARRANGE THE WIRING SO IT IS NOT CRIMPED OR
DRILLING HOLES.PINCHED BY A SHARP METAL EDGE.
When drilling holes in the chassis for installation, takeRoute the cables and wiring away from moving parts (like
precautions so as not to contact, damage or obstruct pipes,the seat rails) or sharp or pointed edges. This will prevent
fuel lines, tanks or electrical wiring. Failure to take suchcrimping and damage to the wiring. If wiring passes
precautions may result in fire.through a hole in metal, use a rubber grommet to prevent
the wireOs insulation from being cut by the metal edge of
the hole.
42-EN |
ACEC
ALPINE
