Presetting radio stations (continued)
Listening to the radio
Other OperationsYou can listen to a radio station either by
selecting a preset station, or by manually tuning
ToDo this
in the station.
Tune in a stationFollow the procedure described in
with a weakOSetting presets through manual
signaltuning�.Listening to a preset station
To set anotherStart over from step 1. After step
N Preset Tuning
station to an3, press . or > repeatedly to
existing presetselect the preset number where you
Preset radio stations in the tunerOs memory first
numberwant to store a new station, then
proceed to step 4.(see OPresetting radio stations� on page 41).
1Press TUNER/BAND repeatedly to
To change the AM tuning intervalselect FM or AM.
(Except for the European and Middle2Press . or > repeatedly to select
Eastern models)the desired preset station.
The AM tuning interval is factory-preset to 9 kHz (or
To select the desired preset number
10 kHz for some areas). To change the AM tuning
interval, tune in any AM station first, then turn off theusing the numeric buttons on the
system. While holding down M and ?/1, turn theremote
system back on. When you change the interval, all the
Press numeric buttons instead of performing
AM preset stations are erased. To reset the interval,
repeat the same procedure.step 2.
NoteTo enter preset number 10 or higher, press >10
You cannot change the AM tuning interval in theand the corresponding numeric buttons. To
Power Saving Mode.enter 0, press 10/0.
TipsExample:
YPressing TUNER/BAND while the power is offTo enter preset number 20, press >10, then 2 and
automatically turns the power on.
10/0.
YThe preset stations are retained for half a day even
if you unplug the power cord or if a power failure
Listening to non-preset radio
occurs.
YTo improve the reception, adjust the suppliedstation
antennas or connect an external antenna.
N Manual Tuning
1Press TUNER/BAND repeatedly to
select FM or AM.
2Press m or M repeatedly to tune in
the desired station.
Tips
YTo improve broadcast reception, reorient the
antennas.
YWhen an FM stereo programme has static noise,
press REPEAT/FM MODE on the remote
repeatedly until OMONO� appears. There will be no
stereo effect, but the reception will improve.
YPress and hold m or M in step 2 above. The
frequency indication changes and scanning stops
when the system tunes in a station (Automatic
Tuning).
GB
42 |
ACEC
SONY
