Additional Information
On operation
PrecautionsY If the system is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lens inside the CD
player or the MD deck. Should this occur, the
On operating voltage
system will not operate properly. Remove the CD
Y Before operating the system, check that the
or MD and leave the system turned on for about an
operating voltage of your system is identical with
hour until the moisture evaporates.
the voltage of your local power supply.
Y When you move the system, take out any discs.
Y The voltage selector is located at the bottom of the
apparatus.
If you have any questions or problems concerning
On safetyyour system, please consult your nearest Sony dealer.
Y The unit is not disconnected from the AC power
On the speaker system
source (mains) as long as it is connected to the wall
This speaker system is not magnetically shielded and
outlet, even if the unit itself has been turned off.
the picture on TV sets may become magnetically
Y Unplug the system from the wall outlet (mains) if it
distorted. In such a case, turn off the power of the TV
is not to be used for an extended period of time.
set once, and after 15 to 30 minutes turn it on again.
To disconnect the cord (mains lead), pull it out by
the plug. Never pull the cord itself.If there seems to be no improvement, locate
the speaker system further away from the TV set.
Y Should any solid object or liquid fall into the
Also, be sure not to place objects in which magnets
system, unplug the system and have it checked by
are attached or used near the speaker system, such as
qualified personnel before operating it any further.
audio racks, TV stands, and toys. These may cause
Y AC power cord (mains lead) must be changed only
magnetic distortion to the picture due to their
at the qualified service shop.
interaction with the system.
Y When you connect the power cord to the wall
outlet, even if the power is off, the system beginsNotes on MDs
charging for remote and timer functions. Therefore
Y If you try to force the shutter open, the disc may be
the surface of this unit become warm, this is
damaged. If the shutter opens, close it immediately
normal.
without touching the disc inside.
On placementY Affix the label supplied with the disc only to the
Additional Information Connecting optional components/
specified label indentation. Do not affix the label
Y Make sure the system fan is on during use.
around the shutter or in other locations. Note that
Place the system in a location with adequate air
the shape of the indentation depends on the disc.
circulation, and do not place anything on top of the
system.
Y Place the system in a location with adequate
ventilation to prevent heat build up.
Y Do not place the system in an inclined position.LabelShutter
Y Do not place the system in locations where it is;position
Extremely hot or cold
Dusty or dirty
Very humid
Y Wipe the disc cartridge with a dry cloth to remove
Subject to vibrationsdirt.
Subject to direct sunlight.
Y Do not expose the MD to direct sunlight or heat
sources such as hot air ducts, nor leave it in a car
On installing
parked in direct sunlight.
When you move the system, remove the CD or MD.
continued
61 |
ACEC
SONY
