left
5. Fit the other end of the Pipe into the mounting
guide on the Finisher Tray side and insert the
Pipe until a click is heard.
Note
At this time, do not press the Finisher up against
the machine, yet.
When Removing the Pipe
Using the tabs on the Finisher side, unlock the
Pipe and pull it out from the mounting guide.
Then, remove the Pipe together with the Feeder
Attachment installed in step 3. Next, pull the Pipe
out of the Feeder Attachment.
1.6.4Adjusting the Position of the Finisher
1. Slowly move the Finisher toward the machine
and check the followings:
Alignment between the Positioning Pin and
the hole in the Finisher (height) (in the rear)
Alignment between Fixing Bracket A and the
fixing bracket on the Finisher (height) (at the
front)
Note
If the parts are not properly aligned with each
other, perform these steps to make an
adjustment.
2. Remove the Lower Front Cover (two screws)
of the Finisher.
D/ Di550I-50i450Rev. 1.1/10.00 |
ACEC
MINOLTA
