MINOLTA DI650 Repair Manual

0,3+,9=0*,Å�)662??Ë�ů?Ã�?´??ĺDÃ�yD5Ã�y??
�ü
ADJUSTMENT
(1) Punch vertical position adjustment (PK-5,(2) Punch horizontal position adjustment (PK-2,
ZK-2)PK-5, ZK-2)
Adjusting the punch horizontal position.Adjusting the punch horizontal position.
StepOperationStepOperation
1Enter the 36 mode.1Enter the 36 mode.
[Adjustment mode menu Screen][Adjustment mode menu Screen]
22
Press "6 Finisher adjustment".Press "6 Finisher adjustment".
[Finisher adjustment mode menu [Finisher adjustment mode menu
Screen]Screen]
33
Press "5 Punch adjustment".Press "5 Punch adjustment".
2 ADJUSTMENT
[Punch adjustment menu Screen][Punch adjustment menu Screen]
4Press "1 Punch kit vertical position adj." Press "2 Punch kit horizontal position
4
or "3 Punch unit vertical position adj."adj." or "4 Punch unit horizontal position
adj."
[Punch vertical position adj.]
5[Punch Horizontal position adj.]
Press the COPY SCREEN key.
5
Press the COPY SCREEN key.
Set papers in the tray, place the original on
6
RADF, and press the START button.Load papers in the tray, place the original
6on RADF, and then press the START but-
7Check the punch vertical position.
ton.
If the punch vertical position is not appro-
Check the paper center and the position of
8priate, press the C button while pressing
punch holes.
down the Utility button.
7Specification (Length between the edge of
[Punch vertical position adj. Screen]paper and the center of punch hole): 10.5
9Press the NEXT or BACK key to select mm (2 holes/4 holes), 9.5 mm (3 holes)
a desired paper size.If the punch horizontal position is not
8appropriate, press the C button while
Enter a value with numeric keys and press
pressing down the Utility button.
the SET key.
10[Punch Horizontal position adj. Screen]
Setting range: -50 to +50
1 step = 0.1 mm9Press the NEXT or BACK key to select
a desired paper size.
Repeat steps 5-10 until the punched posi-
11
tion is within the specification.Enter a value with numeric keys and press
the SET key.
Press the RETURN key to return to the 10
12Setting range: -50 to +50
Punch adjustment menu Screen.
1 step = 0.1 mm
Repeat steps 5-10 until the punched posi-
11
tion is within the specification.
Press the RETURN key to return to the
12
Punch adjustment menu Screen.
2-82