What do I do, if ...
... it is difficult to push the nozzle
Reduce the power setting on the appliance. This
will not reduce cleaning efficiency.
... the motor thermal cut-out is activated
If the motor is overloaded, e.g. due to a full fil-
ter bag or blocked accessory, the thermal cut-
out shuts down the motor. In this case, switch
off the appliance, unplug from the mains, and
leave the motor to cool down.
Check paper filter bag, suction tube and suction
hose; remove any blockage.
The appliance can be switched on again after
approximately 30 minutes.
... the fuse has blown
The fuse may blow if you use other electrical
appliances with high power consumption on the
same electric circuit at the same time as the
vacuum cleaner is in use.
This can be avoided if you set the electronic
power adjuster to the lowest power level and
then select a higher level after switching the
appliance on.
Your vacuum cleaner can be fitted with a gentle
start-up control which reduces the starting cur-
rent to the motor and therefore prevents the
electric circuit cut-out being triggered under
normal conditions. It is possible that there will
be a delay of about 4 seconds in the appliance
starting up on the lowest power level.
? the paper filter is damaged at some stage
and the HEPA filter is dirtied
Remove the HEPA filter, clean (tap out) and
replace.
Insert new paper filter.
16 |
ACEC
PROGRESS
