Connections and settings
Settings
 Sampling Frequency settings
Set the sampling frequency of your sequencer software, the VS-2400CD, and the UA-1000 to
the same setting (44.1 kHz or 48 kHz).
 Master Clock settings
DIF-AT24
Master clock deviceVS-2400CD setting
MASTER CLK switch
PROJECT PARAMETER screen
VS-2400CDR-BUS
M MASTER CLOCL................INT
PROJECT PARAMETER screen
Sequencer softwareADAT
M MASTER CLOCL................R-BUS
You'll also need to set the Master Clock for your sequencer software. For details on this setting, refer to the
owner's manual for your sequencer software.
 Synchronization settings
Set the VS-2400CD's parameters as follows.
Q MMC settings
If using the sequencer software
If using the VS-2400CD as the MMC master
as the MMC master
MIDI PARAMETER screenMIDI PARAMETER screen
M SysEx. Rx. Sw...................... OnM MIDI OUT/THRU .............Out
M MMC MODE....................... SLAVEM SysEx. Tx. Sw......................On
M MMC SOURCE................... R-BUSM MMC MODE.......................MASTER
Q MTC settings
If using the sequencer software
If using the VS-2400CD as the MMC master
as the MMC master
SYNC PARAMETER screenSYNC PARAMETER screen
M SYNC MODE...................... EXTM SYNC MODE ......................INT
M EXT SYNC SOURCE.......... R-BUSM FRAME RATE.....................Select the MTC
M FRAME RATE..................... Same setting as the type.*
software.*M MIDI OUT SYNC Gen.......MTC
* Check the specifications of your sequencer software, and set your software and the VS-2400CD to the same
frame rate.
In order to synchronize operation with your sequencer software, you'll also need to make settings in the
sequencer software. For details on these settings, refer to the owner's manual for your sequencer software.
9 |
ACEC
ROLAND
