Replacing the Light-Source LampReplacing the Light-Source Lamp
The light-source lamp has a service life of approximately 1000 hours. Be sure that the power cord is unplugged from the wall outlet.
When the light-source lamp approaches the end of its service life, degradation progresses rapidly.
The LAMP indicator and the message on the screen warn you that replacement of the lamp is required, as follows:1Remove the lamp-replacement opening
Accumulated used hours cover by loosening screws.
of the light-source lamp Loosen the two screws with a flat-end screwdriver.
Y The LAMP indicator lights up on the projector.Screw
900 hoursY On the screen, OLamp replacement� appears in red.Note
To cancel this message, press the EXIT button.Y The screws are fitted so that they do not come off the lamp-
Y Arrange for a new light-source lamp or replace the light-Lamp replacementreplacement opening cover.
source lamp a little earlier.EXIT
*Every time the projector is turned on, the message appears.
Y The LAMP indicator blinks on the projector.
Y On the screen, OWarning Lamp replacement� appears in red
1000 hours
and the word OWarning� blinks.
Replace the light-source lamp.WarningLamp-replacement
To cancel this message, press the EXIT button. However, the Lamp replacementopening cover
same message will appear every one hour.EXIT
*Only OPERATE button to stop the projector and the EXIT
button are operative.
*Once the projector is turned off, the projector does not turn on
unless the light-source lamp is replaced with new one.
Y The projector is forcibly shut off.
-1010 hours*The projector does not turn on unless the light-source lamp is
replaced with new one.
Be careful not to damage
Purchase a new light-source lamps (Part No. : BHL5001-SU) from the authorized dealer where you purchased the the claw.
projector, or consult the Service Center.2Loosen the screws, raise the handle,
CAUTIONSand pull out the light-source lamp.
Y If the projector is set up in a constricted place which is unsuitable for work, and if you perform replacement work there, this Loosen the two screws with a flat-end screwdriver.Screw
could cause injury. Move the projector to a place large enough for work, and then replace the light-source lamp.Note
Y Use a genuine product for the light-source lamp. If you use other than a genuine product, this could cause a malfunction. Y The screws are fitted so that they do not come off the light-
Also, never use an old light-source lamp. This could cause marked degradation in performance or explode, possibly causing source lamp.
the projector to malfunction or broken pieces to injure you.ENGLISH
Y Do not replace the light-source lamp immediately after the projector has been used. The temperature of the light-source
lamp is still high and could cause a burn. Allow a cooling period of one hour or more before performing replacement.
Y Before starting light-source lamp replacement work, turn off the MAIN POWER switch, and disconnect the power cord from
the wall outlet. If you perform the replacement work with the power cord connected, this could cause injury or electric shock.
Y The light-source lamp used in this projector is a high pressure mercury lamp. Be careful when disposing of the light-source
lamp. If anything is unclear, please consult your dealer.
DEUTSHLight-source lamp
FRAN�AIS
Handle
(To be continued on the next page)
ITALIANO
ESPANOL
5758 |
ACEC
JVC
