8 - Remote operation : Location memories
Location memories
The DM-3200 allows the storage and recall of up to
ten location memories, allowing easy location of the
controlled devices to predetermined cue points.
Selecting the location point display
As explained in ?LOCATE DISPLAY mode? on When this section mentions ?the display? showing
page 33, the LOCATE DISPLAY MODE setting in the location memory values, this refers to the display that
OPTION SETUP screen is used to determine whether the has been selected in this option.
LED time counter shows the location memories as NOTE
they are entered, edited and recalled, or whether they
are shown as ?popup? panels on the LCD display Depending on the settings for frame display (?Edit
screen.Frames? on page 97), the frames value may or may not
be shown on the display when location memories are
being edited, etc.
Storing a location memory ?on the fly?
This procedure allows you to set a location memory, 1 Press the MEMO key. The indicator starts to
regardless of whether timecode is currently being flash.
received or not. If timecode is not currently being 2 Press any of the numeric keys, corresponding
received, the value of the location memory is the last to the ten location memories available.
received value as shown on the time counter on the
display.3 The MEMO indicator stops flashing and the
currently-displayed timecode value is stored in
The value on the time counter, regardless of source, the location memory corresponding to the
is stored as the location memory. This may be time-
code or MTC. numeric key which was pressed.
Manually entering and editing a location memory
The procedure below can be used for editing existing checking and editing of another location mem-
location memories or for adding new ones:ory.
1 Press the EDIT key. The indicator starts to 4 Press the ENTER key when the timecode value
flash.for the location memory has been entered.
2 Press one of the number keys to select the 5 Press EDIT again once to edit another location
location memory which will store the value. memory, or press EDIT twice to exit the loca-
The EDIT indicator lights steadily.tion memory editing mode.
3 Enter the timecode value using the numeric If the CLR key is pressed before the ENTER
keypad. The display shows the value, ?filling key, a location memory entry which has been
up? from the right digit towards the left.made in error is cleared. Pressing ENTER
Or, if the EDIT key is pressed again after the stores the cleared memory.
location memory number has been pressed, It is possible to switch between the capture, edit and
the indicator starts to flash again, allowing the location procedures at any time.
Location to a location memory
When the location memories have been entered, they 3 The controlled device locates to the memory
are recalled in the following way:stored in the location memory.
1 Press the DIRECT key. The indicator lights.What happens next depends on the PLAY MODE
setting (see ?Play Mode? on page 97).
2 Press any one of the numeric keys, corre-
sponding to the ten location memories.
TASCAM DM-3200 User?s Manual 99 |
ACEC
TEAC
