Others
2 Take a picture.
You cannot attach the MC protector and 1 : Press the button lightly to press
the PL filter at the same time.halfway.
If the MC protector/PL filter are tightened
2 : Press the button fully to take the
too much, you may not be able to remove
picture. (Press it as far as it will go.)
them. Do not tighten them too much.
When taking pictures with the flash using
the MC protector or PL filter, vignetting
effect may occur.
If the MC protector/PL filter are dropped,
they may be destroyed. Be careful not to
drop them when attaching them to the
camera.
You can attach the lens cap or the lens
hood when the MC Protector and the PL
Filter are attached.
Read the operating instructions of the MC
protector or the PL filter for details.
MCu ?Multi-coated?
PLu ?Polarizing lens filter?
Using the Remote + About [LOCK] on the remote shutter
You can keep the shutter button pressed
Shutter
fully. This is effective when taking pictures
with [B] (Bulb) (P39) or in burst mode
If you use the remote shutter (DMW-RSL1;
(P64).
optional), you can avoid jitter (camera
While pressing the shutter button fully,
shake) when using a tripod and you can
slide it to the [LOCK] side.
keep the shutter pressed fully when taking
pictures with [B] (Bulb) or burst mode. The
remote shutter works similar to the shutter
button on the camera.
1 Firmly connect the remote shutter
Slide it to the other side to cancel [LOCK].
to the [V OUT/REMOTE] socket on
the camera as far as it will go.
Do not use any other remote shutters
except DMW-RSL1 (optional).
You cannot operate the camera with the
remote shutter in the following cases.
- When the power save mode is canceled
- When you determine the part to be
USBtrimmedV OUT /
REMOTE- When you determine the aspect ratio
conversion
107
VQT0W82 |
ACEC
PANASONIC
