STEP 1 Connection
"The equipment connections described are examples.
"Before connection, turn off all equipment and read the appropriate operating instructions.
"Peripheral equipment and optional cables sold separately unless otherwise indicated.
Connection with a television and video cassette recorder
The connection will allow the video cassette recorder to be used for playback when this unit is turned off. For optimum operation, it is
recommended that this unit be connected as shown below.
indicates included accessories.
Getting started
indicates accessories not included.
Television
Cable from wall
or antenna signalVHF/UHFAUDIO INVIDEO
RF INR LIN
Red White Yellow
Splitter
75 & 75 & coaxial 75 & coaxial cable
coaxial cable Video cassette recorder
cable
VHF/UHFOUTIN
RF IN
YellowVIDEO VIDEO OUTIN
WhiteAUDIOAUDIO LL
VHF/UHFRedAUDIORAUDRIO
RF OUT
Audio/Video cable
This unit?s rear panel
To household
AC outlet
(AC 120V, 60 Hz)
Red White Yellow
Red White Yellow
To IN1
or IN3
Audio/Video cableAC power supply cord
Connect only after all other
connections are complete.
The unit?s RF OUT terminal
The picture and sound signal from this unit does not go through the RF OUT terminal to the television.
Make sure you connect one of the following terminals on this unit to the television: the AUDIO/VIDEO
OUT terminal, the S VIDEO OUT terminal or the COMPONENT VIDEO OUT terminal. If the television
has none of these terminals, consult your local dealer.
"Refer to page 9 if the antenna connector doesn?t match.
Do not connect the unit through a video cassette recorder
Do not place the unit on Video signals fed through video cassette recorders will be affected
amplifiers or equipment by copyright protection systems and the picture will not be shown
correctly on the television.
that may become hot.
The heat can damage the unit.
TelevisionTelevision
This unitVCR
Before moving the unit, ensure the disc tray is empty.
Failure to do so will risk severely damaging the discVCRThis unit
and the unit.
"When connecting to a television with a built in VCR, connect to the
input terminals on the television side, not the VCR side.
 When the unit is not to be used for a long time Quick Start (? page 32)
To save power, unplug it from the household AC outlet. This unit A few seconds after turning on the unit, you can start recording to
consumes a small amount of power, even when it is turned off DVD-RAM.
(approx. 8.2 W).A few dozen seconds after turning on the unit, you can play a disc
or start recording to discs other than DVD-RAM.
RQT8009
7 |
ACEC
PANASONIC
