ENGLISH
9 SAMPLER/DIGITAL SCRATCH/EFFECTOR
H DN-2600FOs ASP (Audio Signal Processor) has three modes - sampler, digital scratch and effector - that can be selected freely according to the
purpose.
2 Sampler(1) Sampler
Y The sound of the disc can be recorded/played for approximately
15 seconds.Recording samples
Y The recorded sound can be looped in the normal or reverse
1Set the ASP to the sampler mode.
direction.
Y The playing speed and level can be changed. In addition, the
Start recording.
key adjust function makes it possible to keep the key constant
Press the PLAY/WRITE button.
even when the playing speed is changed.
2 Digital scratchLit
Y The jog dial can be used to scratch with a feeling similar toON/OFFON/OFF
when scratching with an analog player.PLAY/WRITEPLAY/WRITESamp Write
2 Effector
2-1
Y Three different effect functions can be used to create original
sounds. (In the effector mode, the playing level is 6dB lower
than the normal playing level.)Y The disc plays and the sound is recorded for
approximately 15 seconds. (The STOP LED lights when
recording is over.)
Selecting the ASP modeY Recording can be stopped before the 15 seconds is up by
pressing the STOP button.
1Set the stop mode.
[Sampling the seamless loop]
Set the ASP operation selection mode.Y When the end point (B) is set for the start point (A), the
2
Press the MODE button.standby mode is set at the start point (A) and recording is
started, recording stops at the end point (B). (During
Select the sampler, digital scratch or effector mode.recording, OSamp Load-B� is displayed on the character
2-2
Turn the data master knob (8N9).display.)
Y If the section between points A and B is more than 15
PUSH ENTERseconds long, recording stops after 15 seconds.
] For instructions on setting the standby mode at point A,
3Sampler?refer to OFine-adjusting the start points� (page 16).
D-Scratch?
Playing the sampled sound
Effector?
Press the PLAY/WRITE button.
Set the mode you want to operate.3Y Playback of the sampled sound starts.
Y The stop mode is set automatically once the end of the
Press the data master knob (8N9).
recording is reached.
4
SAMPorDIGI-SorEFFECT
Stopping sampler playback
Lit
Press the STOP button.
4
Y Sampler playback stops.
Clearing the recorded sample
Press the STOP button for at least 2 seconds.
Y The recorded sample is cleared.
5] The sampler playback parameters and the LOOP and RVS
settings are reset to the default values.
17 |
ACEC
DENON
