SET Disassemble/Assemble Method
(Note) Be cautious of FILTER GLASS not being stained with dust or extraneous material. Clean
FILTER GLASS with a clean and soft cloth before assembling.
8-3-2. Assembling/Disassembling procedures without STAND attached.
(1) Lay the Set on soft and safe place.
(2)Detach BACK COVER
(3)Unscrew the lower 2 screws of 3 screws located at the TERMINAL PLATE. (Refer to FIG<19>)
(4)Detach KEY PCB
(5)Detach AC SWITCH & LED PCB
(6)Unscrew 4 FRONT MASK holding screws located at each corner of PANEL BACK PLATE
(Note.1) At least two people must work together when assembling/disassembling FRONT MASK.
(Note.2) Unscrewing these 4 screws separate FRONT MASK and PANEL completely. Therefore,
one person must be holding the FRONT MASK while unscrewing.
(7)Lift Iron handles attached to the each corners of PANEL BACK PLATE perpendicularly by two
workers and put it where clean and safe.
8-4. FILTER GLASS Disassemble/Assemble Method (refer to FIG<18>)
(1)Separate FRONT MASK from the Set.
(2)Put the FRONT MASK down where safe for work.
(3)Unscrew 4 Iron structures screws (LEFT, RIGHT, UP, DOWN) holding FILTER GLASS.
(Note) There are two kinds of screws so check the proper position.
(4)Carefully, separate FILTER GLASS from FRONT MASK
(5)Assembling procedure is in the reversing sequence of disassembling procedure.
(Note.1) Check front and back of FILTER GLASS. Make sure front is facing FRONT MASKs
external view.
(Note.2) Be cautious of FILTER GLASS not being stained with dust or extraneous material. Clean
FILTER GLASS with a clean and soft cloth before assembling.
-48- |
ACEC
DAEWOO
