Connecting your portable dishwasher
A special adapter must be installed on the faucet before the dishwasher can
be connected. Comolete instructions and the adapter are packed with your
dishwasher.
When moving your dishwasher, make sure the 4. Empty any remaining water from the
door is latched. Hold the dishwasher at the top connector.
front corners. 5. Return hoses to storage compartment.
6. Unplug power supply cord and return to
storage compartment.
Electrical Connection
A power supply of 120 volts, 60Hz AC only, 15 or
20 amps, is required. For your personal safety,
this appliance must be grounded. This ap-
pliance is equipped with a power supply cord
having a S-prong grounding plug. To minimize
possible shock hazard it must be plugged into a
Before starting
mating 3-prong grounding type wall recepta-
1. Run water at faucetuntil it is hot. Turn it off cle, grounded in accordance with the National
Electrical Code and local codes and ordi-
nances. If a mating wall receptacle is not avail-
able, it isthe personal responsibility and obliga-
tion of the customer to have a properly
PULL RING grounded 3-prong wall receptacle installed by
2. Pull hoses out of their storage compartment a aualified electrician.
on the back.
HOSE CONNECTOR
3. Pull down on the locking collar while lifting
the hose connector onto the faucet adapter.
4. When the connector snaps into place, re-
lease the locking collar.
5. Turn the hot water on slowly until it is all the
way on.
6. Plug in power supply cord. Power Supply Cord
7. See pages 8 and 9 to start the dishwasher. DO NOT, UNDER ANY CIRCUMSTANCES, RE-
MOVE THE POWER SUPPLY CORD GROUND
While dishwasher is running PRONG.
You can draw water from the faucet while the Converting to built-in
dishwasher is connected. DO NOT draw water
Your Whirlpool Portable Dishwasher can be
while the dishwasher is filling or while water is converted to a built-in (undercounter) model
being pumped out. [This helps prevent a ICN fill
by using conversion kit No. 569056. The kit is
when dishwasher is filling, or mixing drain ,Nater
with fresh water.) available at your Whirlpool dealer or autho-
nzed TECH-CARE? Service Company. Instruc-
1. Press red button on hose connector to get tions are included with the kit.
the water you want. (The faucet is set on hot.
Adjust faucet for the water you want.] Caring for
2. Be sure you return cold water to off, and simulated wood top
that hot water is tull on. The simulated wood top can be used as a
When cycle is finished utility work surface for most kitchen jobs. It is
stronger and more easily cleaned than genu-
1. Turn hot water off. (This can be done after the
ine wood.
last rinse.) The top can be used as a cutting board. Knife
2. Press the red button on the connector to re- marks will be visible but will not seriously
lease the water pressure. damage top. Hot items from the oven can be
3. Lift slightly on the hose connector while pull- placed on the top.
ing down the locking collar. Pull down on Clean with warm, soapy water. For dried-on
foods, use a scouring pad.
14 the connector. |
ACEC
WHIRLPOOL
