2-1-3. UV-44 Board2-1-4. MD-44 Board
1. Remove the panel (L). (Refer to Section 1-2-1.)1. Remove the panel (L). (Refer to Section 1-2-1.)
2. Remove the panel (R). (Refer to Section 1-2-2.)2. Remove the panel (R). (Refer to Section 1-2-2.)
3. Remove the panel (TOP) assembly (Refer to Section3. Remove the panel (TOP) assembly (Refer to Section
1-2-3.)1-2-3.)
4. Remove the SW-44 board. (Refer to Section 2-1-1.)4. Remove the SW-44 board. (Refer to Section 2-1-1.)
5. Remove the front door. (Refer to Section 1-2-4.)5. Remove the front door. (Refer to Section 1-2-4.)
6. Remove the cabinet (L). (Refer to Section 1-2-5.)6. Remove the cabinet (L). (Refer to Section 1-2-5.)
7. Remove the ferrite holder. (Refer to Section 2-8.)7. Remove the ferrite holder. (Refer to Section 2-8.)
8. Remove the DK-44 board. (Refer to Section 2-1-2.)8. Disconnect the seven harnesses from the connectors
9. Remove the paper eject guide assembly. (Refer to(CN903, CN904, CN905, CN906, CN908, CN909 and
Section 2-3.)CN910) and two flexible flat cables from the
10. Remove the E chassis assembly. (Refer to Section 2-connectors (CN901 and CN907) on the MD-44 board.
4.)9. Remove the three screws, then remove the MD-44
11. Remove one screw (BVTP 2.6x8), then remove theboard.
UV fixing plate.
12. Remove the UV cover from the UV-44 board.
13. Remove the two precision screws (P 2x5) and
disconnect one flexible flat cable from the connectorFlexible
CN904
(CN3001) on the UV-44 board, then remove the UV-flat cable
HarnessCN908
Harnesses
44 board.
Harnesses
CN906BVTT
2.6x5
UV coverCN905
UV fixing plate
CN910
UV-44 board
CN909
Precision Px 25
BVTTCN903
2.6x5
CN907CN901
Flexible
BVTPHarnessflat cable
Flexible flat cable2.6x8MD-44 board
CN3001
10. Install the MD-44 board in the reverse order of steps 1
to 9.
14. Install the UV-44 board in the reverse order of steps 1
to 13.
2-2DPP-EX5 V1 |
ACEC
SONY
