Connecting the DPS-5.4NContinued
Controlling AV Components that are Out of Range
You can use the following multi-room kits to control the Controlling Other Out-of-range AV Components
DPS-5.4 when itOs out of range of the remote controller:
If another AV component is out of range of its remote
Y Integra Multi-Room System (IR Remote Controller
controller, you can use a commercially available IR
Extension System)
emitter to retransmit the remote controller signals
Y Multiroom AV distribution and control systems such
received at the DPS-5.4Os IR IN, as shown below.
as those made by Niles¨ and Xantech¨.
IR receiver
Connecting
block
IR IN
IR OUT
DPS-5.4
IR emitter
Remote controller
Other
component
Controlling the DPS-5.4 When ItOs Out of Range: Signal flow
If the DPS-5.4 is located in another room, installed in a
Connect the IR emitter to the DPS-5.4Os IR OUT, and
cabinet, or out of range of its remote controller, you can
place the IR emitter in front of the other AV componentOs
use a commercially available IR receiver to pickup the
remote control sensor (usually located on its front
remote controller signals and feed them to the DPS-5.4,
panel), as shown below. See the instructions supplied
as shown below.
with the IR emitter.
Other component
IR receiver
Connecting
Remote control
blocksensor
from connecting block
IR INIR emitter
Miniplug cable
DPS-5.4
Remote controller
Miniplug
Inside
cabinet
IR Emitter
: Signal flowDPS-5.4
:Signal flow
Connect the IR receiver to the DPS-5.4 as shown below.
Only remote controller signals received by the DPS-
from connecting block
5.4Os IR IN are fed through to the IR OUT. Signals
picked up by the DPS-5.4Os remote control sensor are not
Miniplug cableoutput.
DPS-5.4
21 |
ACEC
ONKYO
