DPX-8030MD
TEST MODE
How to enter the test mode Panel slot disc sensor (CD)
"Test Mode 1, reset while holding down the 1 & 3 keys.Sensor status used for detecting if CD is inserted in slot at
"Test Mode 2, reset while holding down the 1 & 4 keys.subpanel.
Beeps 4 times when inserted CD blocks light to sensor.
Initial status in the test mode
"When set in Test Mode 1 with the 1 & 3 keys. Panel slot disc sensor (MD)
SourceAll OFFSensor status used for detecting if MD is inserted in slot
Volume-30dB (display 20)at subpanel.
AUX volume adjust0dBBeeps 4 times when inserted MD blocks light to sensor.
AUX-INON
BeepSounds every time key is pressed Panel mechanism position mode
EQFLATTo call up mechanism position mode, hold down the ATT key.
SPE/ANAPEAK HOLDStore the panel open position by pressing the key on the
MD Group functionONremote controller.
After storing the panel open position, again press the key
"When set in Test Mode 2 with the 1 & 4 keys.on the remote controller to operation for storing the panel
SourceAll OFFclose position.
Volume-10dB (display 30)
AUX volume adjust0dB Source: CD
AUX-INONStarts song play from track No. 9 at start of disc loading.
BeepProhibitedKey operation only functions when the CD is the source,
EQFLATsong play continues at all other times even if the track No.
SPE/ANAPEAK HOLDis changed during play.
MD Group functionON"key selects only preset tracks. (See table below.)
"key makes downward selections the same as in
Displaynormal operation.
There are many segments on the display and the link between " When 1 key pressed, playback No. 28.
these segments can be checked in Test Modes 1 and 2.
C D
(only in ALL OFF Source)Current trackSearch target
Switch between segments and grids on the display with Tracks other than shown belowNo.9
theFMAMkeys.No.9No.15
No.15No.10
Switch between REAR/N-FNo.10No.11
No.11No.12
Hold down the PLAY/PAUSE key while in tuner-source, to
switch between REAR and N-F.No.12No.13
No.13No.14
To cancel, press the SEL key.1: "Track No. 1" may appear on the display right after play
Correction ROM version display due to the timing.
Display the ROM version by holding down the DSP key
while in ALL OFF source. Source: MD
To cancel press the DSP key again.Starts song play from track No. 7 at start of disc loading.
The following display appears if there is no correction Key operation only functions when the MD is the source,
ROM or if it cannot be loaded.song play continues at all other times even if the track No.
RP0. 00 S0. 00.is changed during play.
Panel mechanism"key selects only preset tracks. (See table below.)
Allows using only the MD Eject key rather than automatic "key makes downward selections the same as in
opening/closing.normal operation.
Displays operating time during opening/closing until about
2 seconds after operation is complete.
Operating time is reset in 0.1 seconds.
10 |
ACEC
KENWOOD
