Filename [DR-MH30US_09Editing.fm]
DR-MH30US_00.book Page 64 Thursday, July 8, 2004 3:32 PMMasterpage:Left0
REMOTE CONTROL
64 EN
Remote Control FunctionsCABLE/DBS
TV AV/VIDEOTVDVD
Remote Control 1/2/3/4 Code Switching1
The remote control is capable of controlling four JVC video units TV% +/-
independently. Each of the units can respond to one of four codes 0 - 9
(1, 2, 3 or 4). The remote control is preset to send 3 code signals CH +/-
because your unit is initially set to respond to 3 code signals. You
can easily modify your unit to respond to 1, 2 or 4 code signals.
TV
Slide the TV/CABLE/DBS/DVD switch to DVD.ENTER
4
1
SET UP
CABLE/DBS
TVDVD
TV Multi-Brand Remote Control
1 - 4
Your remote control can operate the basic functions of your TV set.
In addition to JVC TVs, other manufacturer?s TVs can also be
controlled.
I Turn off the TV using its remote control.
ENTERI Slide the TV/CABLE/DBS/DVD switch to TV.
IMPORTANT:
Although the provided remote control unit is compatible with JVC
televisions, as well as many other models, it may not work with your TV,
or in some instances, may have limited function capability.
I Keep pressing SET UP down during step 1.8
1Enter your TV?s brand code using the number keys, then press
ENTER.
2Press 1 on the unit?s remote control to turn on the TV and try
SET UPoperations ( step 3).
I Once you have set the remote control to operate the TV, you do not
have to repeat this step until you replace your remote control?s
batteries.
I Some brands of TVs have more than one code. If the TV does not
I Keep pressing SET UP down during step 1.function with one code, try entering another.
1Press the number key ?1? for 1, ?2? for 2, ?3? for 3 or ?4? for 4 3Press the corresponding buttons to operate the TV: 1, TV/
to change the remote control code, then press ENTER.VIDEO, CH +/-, TV VOLUME +/-, TV MUTING, number keys.
2Press 1 on the unit to turn off the unit.I For some brands of TVs, you must press ENTER after having
pressed the number keys.
3Press 4 on the unit for over 5 seconds while the unit is turned
off. The code currently set appears on the front display panel.BRAND NAMECODE
4Press 8 on the remote control to change the unit?s code. The JVC01, 03
code currently set on the remote control blinks on the front display HITACHI10
panel for approximately 5 seconds, and is applied to the unit.
MAGNAVOX02
NOTE:MITSUBISHI03
When ?POWER SAVE? is set to ?ON? ( pg. 69), it is not possible to PANASONIC04, 11
change the remote code.RCA05
SHARP06
SONY07
SAMSUNG12
SANYO13
SEARS13
TOSHIBA08
ZENITH09
Page 64Thursday, 8 July 2004 15:30 |
ACEC
JVC
