FUNCTION SWITCH DESCRIPTION
The operation specifications can be selected according to the settingMode 0
of the Function switch. The Function switch is located on the side
OFF
panel to the left of the control panel and cannot be accessed unlessLOCKUNLOCK
3
the front door is opened.Operation from control paneDisabled Enabled
The Function switch is an 8-bit switch, with the top switch numbered4
Command operation from host Enabled Disabled
1 and the bottom switch numbered 8. All of these switches have been
set to OFF when the unit is shipped from the factory. Each switch canOFF
be switched ON by flapping it up toward you.
This is the factory setting. With this combination, the operation from
the control panel or command-based operation from the host can be
selected with the key switch.
1
Switches the initialize element status mode.
2Mode 1
Switches the mail slot tray opening method.
3ON
LOCKUNLOCK
Restricts the disc replacement operation using the3
4mail slot.Operation from control paneEnabled Enabled
4
5678Command operation from host Enabled Enabled
(For use in production line only. Do not set to ON.)
OFF
(For use in production line only. Do not set to ON.)
This combination is convenient when the changer is occupied by an
(For use in production line only. Do not set to ON.)individual. As the operation is not restricted even in the LOCK
position, the key which may be disturbing can be removed permanently
(For use in production line only. Do not set to ON.)
ONfrom the unit.
Mode 2
SWITCHOFFONOFFLOCKUNLOCK
3
Operation from control paneDisabled Enabled
1Command initialize modeAuto initialize mode
4
Command operation from host Disabled Enabled
2Automatic tray openingManual tray opening
ON
The limitations in the specifications for the disc replacement
3
operation using the mail slot can be changed according toThis combination is convenient when the changer is shared by a
4
the combinations of these 2 bits of switch.network. The key is set to the LOCK position in normal use to inhibit
disc replacement, and set to the UNLOCK position only when disc
replacement is required.
Mode 3
ON
LOCKUNLOCK
Switch 1 is used to cause the automatic stored element check to3
Operation from control paneDisabled Enabled
occur in case the disc presence information of the storage elements
4
is Ounknown�. It takes about 5 minutes to check all of the 100 storageCommand operation from host Disabled Disabled
elements.
ON
This combination is the safest setting when the changer is shared by
Switch 2 is used to prevent the mail slot opening operation from
occurring automatically. When the mail slot is used for the disca network. The disc replacement is not permitted unless the person
replacement operation, the operability may be improved if the traywho manages the key performs it on the control panel.
opens automatically. However, when the safety and installation
location are taken in consideration, it is sometimes desirable to use
the manual opening mode with which the tray does not open unless
the button is pressed.
÷ Even in the manual opening mode, the tray cannot always be
opened by pressing the button. This button is valid only when its
indicator is lit.
Switches 5 to 8 are used exclusively in adjustments and testing in the
production lines and must be kept in the OFF positions.
Finally, the following description shows how the limitations in the
specifications for the disc replacement operation using mail slot can
be changed according to the combinations of switches 3 and 4.
13
<DRC1091>
En |
ACEC
PIONEER
