DVD mechanism assembly and parts list
Block No.M2MM
CLAMPER SA
NOTES:31
1.Attach the MAGNET to the CLAMPER.
31
2.Lock the MAGNET and BACK YORK to the CLAMPER firmly
with its 3 hooks.
3.Make sure that none of the 3 hooks of the CLAMPER is
broken/ bent/ changed in shape.30
29
28
27
3 hooks
[FIG-1] LOADING MOTOR - PULLEY Press Fitting. 1
CLAMPER SAMOTOR PULLEY Height should be5.35-0.4-0.1
TOP COVER Back(Measurement between the top part of the PULLEY
26 and the top of the MOTOR Can)
266
-0.1
5.35-0.4
2422
235
[FIG-2] INSULATOR Attachment
NOTES:LOWER CASE
1.Insert the INSULATOR firmly without mixing LOADER SCREW
up the top and bottom side.
2.After the attachment of the INSULATOR, INSULATOR
fasten the LOADER SCREW.LOADER BKT
3.Be sure that the LOADER SCREW is not
fastened at an angle of improperly fastened.
DRAWING FROM
DIRECTION A
25
DRAWING FROM
DIRECTION B
2121[FIG-3] LOWER CASE/ SLIDER Grease Application Point
SLIDER: 6 Grease Application Points
Type of Grease: TAG- 200RAmount of Grease: 8 1mg each
3203
321NOTES:
1.After the attachment of the SLIDER to the LOWER CASE, pull
the SLIDER towards the SNAPFIT (left side). Apply the grease
to the points shown in the figure below.
22.Grease should be applied before the attachment of
TRAVERSE BASE SA.
LOWER CASE
We cannot supply parts that are not
in the Parts List, as they are not
exchangeable because of the 1
design feature. Please handle the
replacement with Mechanism 10
9
Assembly Units.
1114SLIDER Grease Application Points
17LOWER CASE
15
87
13
17
6
c b
8
1712
19"a"
8LOWER CASE: 9 Grease Application Points
BackType of Grease: TAG- 200R
19Amount of Grease: 8 1mg each
Note: Application amount at area "a"
185(left of PULLEY GEAR SHAFT) is 64 4mg.
4NOTES:3.Apply Grease in the center of GEAR Attaching SHAFT.
4.Apply Grease before attaching any kind of GEARS.
8
10
[FIG-3] GEAR Attachment
NOTES:
1.Attachment order of the GEARS is as follows, Correct Phase Adjustment
[GEAR 2] [GEAR 3] [GEAR 1] [PULLEY GEAR].
Be sure to adjust the Phase of GEAR 2 and GEAR 3.Each Phase Adjustment Mark
NOTES:is on the straight line.
<GEAR 2 Phase Mark>
<GEAR 3 Phase Mark>
Make mark as a Phase
Adjustment Mark
Make the salient of the outer circumference
16of GEAR 3 as a Phase Adjustment Mark. 9
3-4(No.XA019) |
ACEC
JVC
