DSR-45/45P
3-18.MAIN SLIDER, MAIN SLIDER ARM AND PENDULUM STOPPER ASSEMBLY
Disassembly: Remove them in order of 1,2,3Disassembly of each part
The main slider controls several parts. Before removing the main
slider, remove OBrake arm S� at the front of the chassis while re-
1Main sliderferring to OInformation� on page 5-4. Otherwise, the main slider
cannot be removed.
Brake arm S
Pendulum23Main slider arm
stopper assembly
Fixing shaft of Main slider
main slider arm
The main slider is fixed by the two shafts and the two
bent portions at the rear of the chassis. The main slider
can be removed when it is moved to the rightmost end
( positions).
Shafts
Fixing hole ofBent portions
main slider arm
Bent portions
Assembly: Attach them while referring to the figure
above or below and the descriptions.
Assembly of each part
Attach each part while referring to the figure above or belo1 Insert the main slider arw. Whenm into the fixing hole and attach
attaching the parts, adjust the positions carefully while referringit to the fixing shaft at the front of the chassis while
to the instructions in the figure below. Because these positioningreferring to the figure above. (To facilitate assembly,
will be used as a reference when assembling in future, make surstick adhesieve tape so that the main slider arm does not
to adjust the positions and phases correctly.drop.)
[Rear side of chassis]2 Perform assembly so that the main slider can pass under
the bent portion of the chassis. If ORatchet brake T�
remains, move down the ORatchet brake T� as shown in
the left figure and attach the main slider.
3 Carefully attach the pendulum stopper assembly so that
1the two shafts fit in the two long holes of the main slider.
Main slider
Pendulum stopper assemb3ly4
Main slider arm
Pendulum stopper assemblyshafts
5
4 Attach the shaft of the main slider arm to the long hole
of the main slider.
Main slider
5 Move the main slider to the leftmost end so that the
small positioning hole of the main slider is superimposed
on the small positioning hole of the chassis, and fix the
2
The shaft of the ratchet brake T Move the main slider so that main slider. The position where the main slider is fixed
will be used as a reference during assembling and phase
should be at the position where the positioning holes are adjustment in future.
it can be viewed fromthe outside superimposed.(To avoid affecting the main unit, fix the reel motor and
as shown in the figure.
main slider with adhesive tape, etc.)
5-19 |
ACEC
SONY
