Using the Remote Controller with Other
Components
You can use the DTR-7.4Os remote controller (RC-
Use the number buttons to enter
550M) to control your other AV components, including 5
the 4-digit remote control code.
those made by other manufacturers. To do this you can:
Y Enter a remote control code for the component that
you want to control (e.g., DVD, TV, VCR).
Y Learn commands directly from the other componentOs
remote controller (see page 94).
If the code is accepted, the following
Y Use the Macro function to learn a sequence of actions
appears on the display for a while, and
(see page 95).
then the normal display reappears.
Y You can also edit the remote controller modes (see
page 97).
Entering a Remote Control Code
If the code is not accepted, after the
By entering the appropriate remote control code for message ORETRY� has been displayed,
each of your components, you can control each compo-the code entry display reappears, and
nent by selecting the relevant remote controller mode: you should try entering the code again.
DVD, TV, VCR, CBL (cable), or SAT (satellite).To cancel this procedure at any point,
press the Custom button.
Look up the appropriate remote
1
control code for the component.Select the remote controller mode,
6
See ORemote Control Codes� on page point the remote controller at the
90-91.component, and check its opera-
tion.
Press and hold down the Custom
2The remote controller buttons that can
Custombutton for more than three sec-be used in DVD mode are shown on
onds.page 84. Those that can be used with the
The remote controller enters Custom TV, VCR, CBL, and SAT modes are
mode.listed on pages 92 and 93.
Roll the scroll wheel to select
3Remote Control Codes for an Onkyo DVD player
OPRGRM,� and then press the
scroll wheel.The remote control code that you use with an Onkyo
DVD player depends on whether itOs connected via ,
as follows:
5001: Use this code if youOve connected an cable
and an RCA/phono analog audio connection cable to
your DVD player. This is the default setting, so if
youOre using , you donOt need to change it. Point Remote Controller
Roll the scroll wheel to select the
4
the remote controller at the DTR-7.4 to operate the
the remote controller mode you
DVD player.
want to use with the component,
5002: Use this code if your DVD player doesnOt have
and then press the scroll wheel.
an socket, or youOre not using . Point the
The following remote controller modes
remote controller at the DVD player to operate it.
can be selected: DVD, TV, VCR, CBL,
or SAT.
89 |
ACEC
INTEGRA
