Side clip (on some models)
The side clip holds lightweight plastic items such as cups, lids, or
bowls in place during washing.
12 place setting
 Place items so open ends face down for cleaning and
draining.
 Load glasses in top rack only. The bottom rack is not
designed for glasses. Damage can occur.
To move a clip
 Place cups and glasses in the rows between tines. Placing 1. Pull the clip up and off horizontal rack wire.
them over the tines can lead to breakage and water spots.
2. Reposition the clip on another horizontal rack wire.
 China, crystal, and other delicate items must not touch each
other during dishwasher operation. Damage may occur.Utensil clip (on some models)
 Load lightweight plastic items in the top rack only. Only
plastic items marked ?dishwasher safe? are recommended.The utensil clip holds specialty cooking items (wooden spoons,
spatulas, and similar items).
 Load plastic items so the force of the spray does not move
them during the cycle.
 To avoid chipping, do not let stemware touch other items.
 Small bowls, pans, and other utensils can be placed in the
top rack. Load bowls in the center section for best stability.
Cup shelves (on some models)
Fold down the extra shelf on the left-hand or right-hand side of
the top rack to hold additional cups, stemware or long items such To move a clip
as utensils and spatulas.
1. Pull the clip up and off horizontal rack wire.
NOTE: The features on your dishwasher may vary from those
shown below. 2. Reposition the clip on another horizontal rack wire.
Adjustable 2-position top rack (on some models)
You can raise or lower the top rack to fit tall items in either the top
or bottom rack. Raise the top rack to accommodate items up to
9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or
lower the top rack to accommodate items up to 11" (28 cm) in
both the top and bottom racks. Two adjusters are located on
each side of the top rack. Each adjuster has 2 preset positions.
The high and low positions are marked on the adjuster.
To adjust the top rack
1. Hold the top rack with one hand near the adjuster.
Light item clips (on some models)
The light item clips hold lightweight plastic items such as cups,
lids, or bowls in place during washing.
2. With the other hand, pull out the top of the adjuster.
3. Raise or lower the rack to one of the preset positions.
To move a clip4. Release the adjuster.
1. Pull the clip up and off the tine.5. Repeat the steps for the remaining adjusters.
2. Reposition the clip on another tine.NOTE: The top rack must be level.
8 |
ACEC
WHIRLPOOL
