Using Rinse Agent Dispenser
Rinse agent dispenser
Keep the rinse agent dispenser filled with a liquid
rinse agent. A rinse agent greatly improves
the drying of dishes by helping water flow
off of them during the last rinse. A rinse agent
also keeps water from forming droplets and drying
as spots. A small amount of rinse agent is auto-
matically released into the rinse water during the
final rinse of each cycle.
For best drying results, check the
dispenser periodically to see if it needs
refilling.
To check dispenser
The center of the Fill Indicator Cap will be clear
when dispenser needs refilling. An ?E? will also
be visible inside the dispenser when the cap is
removed and the dispenser is empty.
On some models:
1. Press the flexible clear top of the Fill Indicator
Cap to draw rinse agent into cap.
NOTE: You may need to press cap two or
three times to remove all of the air bubbles
from the cap.
2. When rinse agent does not show in cap, even
afler pressing flexible cap several times,
dispenser needs refilling.
To fill dispenser
The dispenser will hold 6 ounces of rinse agent.
Under normal conditions, this will last about 3
months. You do not have to wait until the dispenser
is empty to refill it, but do not overflll It.
Keep rinse Make sure the dishwasher door is fully open
dispenser f before removing the Fill Indicator Cap. Do not fill
best drying past the smallest opening In the lower part of the
---.- dispenser. If you overfill, excess rinse agent can
come out. This will not harm ihe dishwasher, but
could cause over-sudsing. Clean up any spilled
rinse agent with a damp cloth. Replace the Fill
Indicator Cap and keep it tightly closed.
NOTE: Because your dishwasher is designed to
use a liquid rinse agent, you do not need to use a
solid or bar-type rinse agent.
13 |
ACEC
WHIRLPOOL
