SETTING THE CONTROLS
Selecting cycle options
If desired, press one or more Option pad(s).Air Dry
You can press an Option pad after the
When Air Dry is selected, the air in the
dishwasher starts as long as the cycle has
dishwasher is not heated during
not passed the point that the option is used.AIR
DRYthe Odry� portion of a cycle. Using
For example, you can press Air Dry any timeAir Dry helps save energy, but
before the Cycle Control knob reaches Dry.dishes take longer to dry and
some spotting can occur. Some
Hi-Temp Washitems (such as plastics) may need towel
When Hi-Temp Wash is selected, thedrying. For best drying, use a liquid
dishwasher heats the water duringrinse agent.
HI-TEMP
WASHthe main wash of the Light, Normal,
NOTE: The dishwasher automatically heats
and Heavy cycles. Heating the
the air in the dishwasher during the Odry�
water helps improve washing
portion of the cycle unless you select Air Dry.
results. The Pots-N-Panscycle
For 900 Model Series:
automatically uses Hi-Temp Wash.
Y Always select the Air Dry option when
NOTE: The Cycle Control knobdoes not
using the Rinse-Wash Later cycle.
move while water is being heated. Once the
For 911 and 915 Model Series:
water reaches the proper temperature, the
Cycle Control knobwill begin moving again. Y The Air Dry option is automatically selected
for the Rinse-Wash Later cycle.
Changing a cycle setting
You can change a cycle setting anytimeNOTE: Turning the Cycle Control knob
during any cycle.can cause the covered section of the
1.Lift up the door latch to stop the cycle.detergent dispenser to open and release
the detergent. Check the covered section
2.Turn the Cycle Control knob clockwise to
if setting a cycle.
the desired cycle.
5.Close the door firmly until it latches. The
3.If desired, press one or more Option pad(s).
dishwasher starts the new cycle.
4.Check the detergent dispensers. They
must be filled properly for the new cycle.
Changing an option setting
You can change option settings anytime
during a cycle as long as the
RESET
OPTIONScycle has not passed the point
that the option is used. For
example, you can press Air
Dry anytime before the Cycle
Control knobreaches Dry.
1.Press the Reset Options pad.
2.Press 1 or more Option pad(s).
17 |
ACEC
WHIRLPOOL
