5678
7.1.9 DISASSEMBLY
Note: Even if the unit shown in the photos and illustrations in this manual may differ from your product, the procedures
described here are common.
A
Diagnosis of the DVDM Assy
(SCRB Assy)
1Bonnet and Tray PanelThis is not installed in your product.
1Remove the Bonnet by removing the five screws.
2Press the STANDBY/ON button to turn on the
power.2 6
3Press the 0button to open the Tray.
4Remove the Tray Panel.
5Press the 0button to close the Tray.B
6Press the STANDBY/ON button to turn off the
power.
4
35
3
5Tray
Tray Panel
C
How to open the Tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the
bottom of the unit, and slide the projection of the Drive
Gear in the Loading Mecha. Assy in the direction of
the arrow, as indicated in the photo. If the Tray pops
out a little, fully pull it out by hand.D
Screwdriver (small)
Projection
Slit
Drive Gear
Loading Mecha.Assy
E
Tray open
Screwdriver (small)
F
DV-260-S63
5678 |