Settings are canceled.
Troubleshooting
When the power is turned off by power failure or by
English
Incorrect operations are often mistaken for trouble andunplugging the power cord, settings will be canceled.
malfunctions. If you think that there is something wrong\ Before unplugging the power cord, press
with this component, check the points below. STANDBY/ON and check that O--OFF--�
Sometimes the trouble may lie in another component.disappears in the display.
Inspect the other components and electrical appliances
being used. If the trouble cannot be rectified even afterNo picture or no color.
exercising the checks listed below, ask your nearestConnection is incorrect.
PIONEER authorized service center or your dealer to\ Check that cord connections are correct and that
carry out repair work.plugs are firmly connected.
Internal player settings are incorrect.
The disc table comes back out automatically, shortly\ If AV CONNECTOR connections have been made,
make sure that the Setup screen Video menu
after the disc table is closed.
[Video Out] setting corresponds to the
The disc is dirty or warped.
capabilities of the TV or monitor that connections
\ Refer to �Disc CareO (page 48).
have been made to (page 28).
The disc is not placed properly on the disc table.
Operation (settings) of TV or AV amplifier is not
\ Use the disc tray guide to align the disc (page 19).appropriate.
Region number does not conform with this unit.\ Be sure that your TV, receiver, or amplifier is set
up to view DVD playback.
\ If the region number on the disc does not match
the number on the player, the disc cannot be used
The screen is stretched or aspect does not change.
(page 54).
The multi aspect setting is not appropriate.
There is condensation on the operating section of the\ Change the aspect setting in the [TV Screen]
player.
setting in the Setup screen Video menu to the
\ Allow time for condensation to evaporate. If playerscreen type most appropriate to the TV or monitor
is near an air conditioning unit, you should moveyou are using (page 27).
the player (page 49).
Picture disturbance during playback or dark.
Playback is not possible.
This player is compatible with Macro-Vision System
The disc has been loaded upside down.copy guard. Some discs include a copy prevention
\ Check that the disc has been loaded with the labelsignal, and when this type of disc is played back,
side facing up.stripes etc., may appear on some sections of the
picture depending on the TV.
mark appears on screen.\ This is not a malfunction.
The selected function does not operate for that disc.
The position of the TV SYSTEM switch was changed
during player operations.
mark appears on screen.
\ Switching the position of the TV SYSTEM switch
The operation is prohibited by the player.
is not effective if a disc is playing. Stop playback
before performing this operation.
Picture playback stops and the operation buttons
cannot be used.Discs respond differently to particular player functions
\ Stop disc playback (press STOP 7), then startwhich may result in the screen becoming black for a
playback again.brief instant or shaking slightly when the function is
executed.
New settings made in the Setup screen menus while\ These problems are largely due to differencesADDITIONAL INFORMATION
a disc is playing are ineffective.between discs and disc content and are not
malfunctions of this player.
Some settings can be changed while a disc is playing,
but are not effective. This is not a malfunction.
\ Make the same setting when the player is
stopped.
\ Stop disc playback (press STOP 7), then start
playback again. When playback is resumed, the
new settings should be in effect. Please note that
making settings in the Setup screen menus may
cancel the resume function.
When making changes in the Setup screen menus,
is displayed.
There is a Video CD or CD loaded in the player and the
setting that was changed only applies to DVD
performance.
\ The settings will be effective the next time a DVD
is loaded.
51
En |
ACEC
PIONEER
