Connecting the DV-CP802NContinued
ODTS>PCM� (see page 50). Otherwise an unpleasant
Connecting a Stereo Amp
digital noise may be heard, which may damage your
This section explains how to connect the DV-CP802 to a equipment.
stereo amp or receiver for sound quality better than that Y The output formats for the OPTICAL and COAXIAL
possible with most TVOs built-in speakers. This is great digital audio outputs can be set independently (see
for listening to your CDs and MP3s, and DVDs and page 50).
VCDs will sound better too. You can also enjoy Dolby YNever connect the DV-CP802 to the AC-3RF input on
Surround, if your amp supports Dolby Pro Logic.a Dolby Digital receiver. The AC-3RF format is not
supported by the DV-CP802.
Analog Connection
Use an RCA audio cable to connect the DV-CP802Os
Connecting Components with
ANALOG AUDIO OUTPUT to a pair of analog audio
inputs on your amp or receiver, as shown.With (Remote Interactive) you can control the
DV-CP802 by using the remote controller supplied with
Stereo amp(white)
your Onkyo -compatible AV receiver.
L
R
(red)Onkyo AV receiver
ANALOG
INPUT
RCA cableREMOTE CONTROL
1(white)DIGITAL INL
OPTICAL
Signal flow
L
R
ANALOG
RINPUT
L(red)
RTo use you must make
an analog audio connection
(RCA) between the DV-CP802
and the other component,
even if they are connected
Notes:digitally.
cable
Y Set the Analog Audio Out setting to O2 Channel� (see
(Supplied)
page 22, 52).1
Y If your amp has a built-in Dolby Pro Logic decoder, to L
enjoy DVDs that bear the Dolby Surround logo, set the AUDIO OUTPUT
DIGITALR
Analog Audio Out 2 Channel setting to OLt/Rt� (see OPTICALOPTICALCOCOAXIALAXIAL
page 52).
Digital ConnectionL
RREMOTECONTROL
Use an optical (or coaxial) digital audio cable to connect
the DV-CP802Os OPTICAL (or COAXIAL) DIGITAL
AUDIO OUTPUT to an optical (or coaxial) digital audio
input on your amp or receiver, as shown.
Notes:
OPTICALCOAXIAL
Y Push each plug in all the way to make a good connec-
tion.
Y Use only cables for connections.
YTo use you must make an analog audio connec-
OPTICALtion (RCA) between the DV-CP802 and Onkyo AV
receiver, even if they are connected digitally.
AV receiver
Y The DV-CP802 has two sockets. You can connect
COAXIAL
either one to the Onkyo AV receiver. The other socket
is for connecting additional -compatible compo-
Signal flow
nents.
Notes:Y Connect the DV-CP802Os sockets to only Onkyo
Y Be sure to set the Dolby Digital Out setting to ODolby components. Connecting to other manufacturerOs
Digital>PCM,� and set the DTS Out setting to components may cause them to malfunction.
20 |
ACEC
ONKYO
