English
Enhanced useCleaning Discs
Some problems occur because the disc inside the player is
Audio Direct Modedirty. To avoid these problems clean your discs regularly, in
? Audio Direct feature can be activated or deactivated bythe following way:
pressing the AUDIO DIRECT button on front of the player.? When a disc becomes dirty, clean it with a cleaning cloth.
Wipe the disc from the centre out, in a straight line.
This feature will minimise any interaction between theCaution:
video and audio circuity thereby allowing maximum� Do not use solvents such as benzine, thinner,
audio quality produced from the player.commercially available cleaners, or anti-static
1Press AUDIO DIRECT button on front of the player.spray intended for analog discs.
� Video section of the SACD player will be Oswitched off�
and pictures will disappear on the TV screen.Diagnostic program
2Press AUDIO DIRECT button again;
� Pictures will appear on the TV screen.If the player is still faulty you can start the Diagnostic
Program in the player.
? The Audio Direct cannot be activated when playing a video
disc (e.g., DVD/VCD/SVCD).You can operate the Diagnosis Program by following the
? Audio Direct mode will be deactivated whenever thestep-by-step instructions below.
player is switched to standby or off.
Instructions
When AUDIO DIRECT is switched to ON:
1Switch the player OFF with the ON/OFF button.
? OSD related keys are disable (e.g., SYSTEM MENU, TITLE,2Press the / OPEN/CLOSE and ; button simultaneously
CHAPTER, etc.)and keep them pressed while you turn the player ON.
? If a video disc is inserted into the player, audio direct mode
will be automatically deactivated and picture will be� On the display the message BUSY appears together
with a counter that counts down as the test is running,
displayed on the TV screen.reaching zero by the end of the test.
Note:� After a few minutes, the message on the local display
� It is recommended that the Audio Direct mode is turned offchanges from BUSY to FAIL or to PASS.
before you play any video disc.� If the message FAIL appears on the display, there is
? The player will react similar to a CD player. Thus for audioapparently a failure in your player and your player should be
discs (e.g., CDDA, SACD) it is possible use T NEXT /repaired.
3Consult your dealer or the Philips Customer Care Centre
S PREVIOUS keys for track selection.for the nearest Service Repair Shop in your country. The
phone number is given in your warranty booklet.
4If the message PASS appears on the display, there is
apparently no failure in your player. In this case the failure
can be caused by incorrect interpretation of the operating
instructions, the use of a wrong disc or the fact the your
player is incorrectly connected. In this case, you should
consult your dealer or the Philips Customer Care Centre
for further assistance in solving the problem.
5If the problem remains, return to point 3 of this instruction
to find the nearest repair shop.
6Switch the player OFF with the ON/OFF button to leave
the diagnostic program.
30OPERATION |
ACEC
PHILIPS
