6-5. DRIVE MANUAL OPERATION0. Disc Check Memory
On the Test Mode Menu screen, select [2], and the manual opera-
tion menu will be displayed. For the manual operation, each servoDisc Check
on/off control and adjustment can be executed manually.
1. SL Disc Check
## Drive Manual Operation ##
2. CD Disc Check
3. DL Disc Check
Operation Menu
1. Disc Type
2. Servo Control
3. Track/Layer Jump0. Reset SLED TILT
4. Manual Adjustment
5. Auto Adjustment
6. Memory Check
0. Disc Check MemoryOn this screen, the mirror time is measured and written to the
EEPROM to check the disc type. First, set a DVD SL disc and
Exit: RETURNpress [1], then set a CD disc and press [2], and finally set a DVD
DL disc and press [3]. The measured mirror time is displayed re-
spectively.
In using the Manual Operation menu, take care of the following
points. These commands do not provide protection, thus requiringThe adjustment must be executed more than once after default
data were written.
correct operation. The sector address or time code field is dis-
played when a disc is loaded.From this screen, you can go to another mode by pressing >
or . key, but you cannot enter this mode from another mode.
1. Set correctly the disc type to be used on the Disc TypeYou can enter this mode from the Operation Menu screen only.
setting screen.
The Disc Type setting must be performed after a disc1. Disc Type
was loaded.
The set Disc Type is cleared when the tray is opened.Disc Type
2. After power ON, if the Manual Operation was selected,1. Disc Type Auto Check
first perform OReset SLED TILT� by opening 1. Disc Type2. DVD SL12cm
3. DVD DL12cm
screen.4. CD12cm
3. In case of an alarm, immediately press the x button to
5. SACD12cm
stop the servo operation, and turn the power OFF.6. DVD SL8cm
7. DVD DL8cm
Basic operation (controllable from front panel or remote com-8. CD8cm
mander)9. LCD8cm
[POWER] : Power OFF0. Reset SLED TILT
x : Servo stopEMG. 00
A (Open/Close) : Stop+Eject/Loading
O : Return to Operation Menu or Test Mode MenuOn this screen, select the disc type. To select the disc type, press
> , . : Transition between sub modes of menu
the number of the loaded disc. The selected disc type is displayed
[1] to [9], [0] : Selection of menu and itemsat the bottom. Selecting [1] automatically selects and displays the
Cursor [Q]/[q] : Increase/Decrease in manually adjusted valuedisc type. In case of wrong display, retry ODisc Check Memory�.
Also, opening the tray causes the set disc type to be cleared. In
this case, set the disc type again after loading.
In performing manual operation, the disc type must be set.
6-7 |
ACEC
SONY
