3-2
Reprogramming of DVD version MatrixProcedure to upgrade software
After repair, the customer setting and region code may be1) Power up the set.
lost. Reprogramming will put the set back in the state in2) Open tray by press "OPEN/CLOSE" button on the set
which it has left the factory, ie. with the default setting andor press and hold "STOP" button on the RC.
the allowed region code.3) Place upgrade CD-ROM onto tray and close.
4) The set will response and display the following:
To reprogram do as follows:- LOAD [After the disc is read, the tray will open for
1) Power up the set.you to remove the disc]
2) Open tray by press "OPEN/CLOSE" button on the set- ERASE
or press and hold "STOP" button on the RC.- WRITE
3) Press the following buttons on the Remote Control:- ERROR [if upgrade is unsuccessful]
<9> <9> <9> <9> <AUDIO> <1> ........ for DVP720SA/00- UPG END -> PHILIPS [if upgrade is successful]
<9> <9> <9> <9> <AUDIO> <2> ........ for DVP720SA/17- DISC->CLOSE->LOAD [Tray will close indicating
<9> <9> <9> <9> <AUDIO> <3> ........ for DVP720SA/02that the upgrade process is completed]
<9> <9> <9> <9> <AUDIO> <4> ........ for DVP720SA/055) The whole process should not take more than 5
<9> <9> <9> <9> <AUDIO> <5> ........ for DVP720SA/69minutes.
<9> <9> <9> <9> <AUDIO> <6> ........ for DVP720SA/75
<9> <9> <9> <9> <AUDIO> <7> ........ for DVP720SA/78Caution: Do not unplug the set until upgrade is completed.
4) The display shows 'YYYY-ZZ' and the tray will close.
YYYY = model number (eg. 0720, 3900, etc.)
ZZ= stroke version (eg. 00, 02, 05, etc.)Trade Mode
Trade mode is a feature that will block all set keys when
enabled. It is for dealers to prevent customers from
Procedure for check Software versionremoving disc, changing source etc using the set keys.
1) Power up the set.Rotary and Remote Control (RC) keys are still allowed in
2) Open tray by press "OPEN/CLOSE" button on the setTrade mode.
or press and hold "STOP" button on the RC.
3) Press "DISPLAY" button on the Remote control.To activate Trade Mode:
4) The TV screen will shows:1) Power up the set.
SD6.1 Vxx YYYY-ZZ P QQ2) Open tray by press "OPEN/CLOSE" button on the set
SERVO: GGGGGGGG REG:Dor press and hold "STOP" button on the RC.
3) Then press buttons <2> <5> <9> on the RC.
xx= version number4) The display shows 'TRA ON' and the tray will close.
YYYY= model number (eg. 0720, 3900, etc.)Trade Mode is now enabled.
ZZ= stroke version (eg. 00, 02, 05, etc.)
P / D= region codeTo deactivate Trade Mode:
QQ= version number of front uProcessor1) Power up the set.
GGGGGGGG = version for servo code2) Open tray by press and hold "STOP"button on the RC.
3) Then press buttons <2> <5> <9> on the RC.
4) The display shows 'TRA OFF' and the tray will close.
Trade Mode is now disabled.
ACEC
PHILIPS
