DVP-CX985V
Error Codes List4-4. DRIVE AUTO ADJUSTMENT
00: Error not detected
01: RAM write/read data discordDVD reference disc
03: EEPROM NGSingle Layer
04: Flash memory clear errorHLX-503 (J-6090-069-A) (NTSC) OR
05: Flash memory write errorHLX-504 (J-6090-088-A) (NTSC)
06: Flash memory read data discordDual Layer
08: ARP register read data discordHLX-501 (J-6090-071-A) (NTSC) OR
09: ARP Tt RAM data bus errorHLX-505 (J-6090-089-A) (NTSC)
10: ARP Tt RAM address bus error
11: ARP RAM read data discordCD reference disc
12: Servo DSP NGYEDS-18 (3-702-101-01) OR
13: RF Amp NGPATD-012 (4-225-203-01)
14: 1935 SDRAM NG
15: ARP t 1935 video NGOn the Test Mode Menu screen, press [1] key on the remote com-
16: ARP t 1935 audio NGmander, and the drive auto adjustment menu will be displayed.
1A:System call error (Function not supported)
1B:System call error (Parameter error)## Drive Auto Adjustment ##
1C:System call error (Illegal ID number)
20: System call error (Time out)Adjustment Menu
22: Resistor installation error
0. ALL
50: SACD Decoder W/R NG1. DVD-SL
52: Video Encoder W/R NG
2. CD
55: External RAM W/R NG3. DVD-DL
90: Error occurred4. LCD
91: User verification NG
92: Diagnosis cancelled_
Exit: RETURN
Normally, [0] is selected to adjust DVD (single layer), CD, and
DVD (dual layer) in this order. But, individual items can be ad-
justed for the case where adjustment is suspended due to an error.
In this mode, the adjustment can be made easily through the op-
eration following the message displayed on the screen. Which disc
is currently adjusted is displayed on the fluorescent display tube.
0. ALL
You will be asked if EEPROM data are initialized or not, and for
this prompt, select [0] and press the [ENTER] key. First, the servo
setting data in EEPROM, Emergency History and Hour Meter are
cleared to initialize. Then, [1] DVD-SL disc, [2] CD disc, and [3]
DVD-DL disc are adjusted in this order. Because the changer model
can accept multiple discs in advance of adjustment, adjustments
can be continued by exchanging discs automatically whenever an
adjustment is completed following the instruction on screen. You
can exit the adjustment by pressing thex button. In adjusting
each disc, the mirror time is measured to check the disk type. In
the auto adjustment, whether the disc type is correct is not checked
unlike conventional models, and accordingly, take care not to in-
sert a different type of disc.
Three kinds of discs can be set in advance. In this case, set discs in
order to the displayed number with following the massage. Every
time after adjusting a disc, the disc is replaced and adjustment is
continued automatically.
Set Disc
Disc slot number 1: DVD-SL
Disc slot number 2: CD
Disc slot number 3: DVD-DL
27 |
ACEC
SONY
