PIONEER DVR-220-S Repair Manual

5678
7.1.1 CPRM ID NUMBER AND DATA SETTING
Entering the ID Number and ID Data for DVD Recorder
A
For the DVD recorder,it is necessary with the recoding/playback of DVD�RW disc to set an individual number (ID number) and ID data to
each recorder. If the number and data are not set correctly with the following procedure, operations in the future may not be guaranteed.
You will find the ID number to be set on the ID label on the rear panel.
Important: If no ID label is found on the rear panel, write down the specified ID number by checking it according to "How to
confirm the ID number" shown below.
JIGS AND MEASURING INSTRUMENTS
The Input is Necessary When:
Y " CPRM ERR" is displayed on the FL display immediately after the
power is turned on or in Stop mode.
Y When the MAIN ASSY , DRIVE ASSY or the FLASH ROM is
exchanged.
B
DVD Recorder Data Disc
Service Remote Control(GGV1179)(*) Refer to
Unit (GGF1381) "7 Jigs list".
Note:
Be sure to enter the ID number in Stop mode.
Use the service remote control (GGF1381) for operations. Only opening/closing of the tray are performed from the player.
The ID data disc is swept out automatically after the recorder have read the data from it.
How to Input the ID Number and ID Data
1 To enter the input mode, press ESC + STEREO sequentially in 4 When the ID number has been registered, the unit enters the ID
a status with no ID number set, such as after FLASH-ROM data input mode. (The FL display indicates "INSERT ID.")
downloading.In this condition, place the ID data disc on the tray and close the
tray using the CLOSE key "7/0" on the player.C
[Recorder's ID Data Setting]
2 As number input is enabled when the unit enters the input
mode, input the 9-digit ID number.
(The entered number is also displayed on the FL display.)
[Recorder's ID Number Setting]
<CLEAR> Exit
ID Number ?
2> - - - - - - - - -
4Insert The ID Data Disc !
<CLEAR> Exit
D
Input ID Number !
5 While the data are being read, the message shown in the figure
at left is displayed on the screen.
(The FL display indicates "LOAD ID.")
3 After inputting the number, press SEARCH to register the ID
number.[Recorder's ID Data Setting]
[Recorder's ID Number Setting]
ID Number ?
> 0 0 0 0 0 0 0 0 1 OK ?
E
<PLAY> Compare Mode
3<SEARCH> Enter
5Loading The ID Data Disc !
Input ID Number !
F
75
DVR-220-S
5678