DVR540H_WV_EN.book 3Z8 ???- ??e?- xý
Å
U xý9=?p?? Â
Operating EnvironmentCAUTION
Operating environment temperature and humidity:The STANDBY/ON switch on this unit will not
+5 C to +35 C (+41 F to +95 F); less than 85 %RH completely shut off all power from the AC outlet.
(cooling vents not blocked)Since the power cord serves as the main disconnect
Do not install this unit in a poorly ventilated area, or in device for the unit, you will need to unplug it from
locations exposed to high humidity or direct sunlight (or the AC outlet to shut down all power. Therefore,
strong artificial light)D3-4-2-1-7c_A_Enmake sure the unit has been installed so that the
power cord can be easily unplugged from the AC
outlet in case of an accident. To avoid fire hazard, VENTILATION CAUTION
the power cord should also be unplugged from the
When installing this unit, make sure to leave space
AC outlet when left unused for a long period of time around the unit for ventilation to improve heat
(for example, when on vacation).D3-4-2-2-2a_A_En
radiation (at least 10 cm at top, 10 cm at rear, and
10 cm at each side).
WARNING
Slots and openings in the cabinet are provided for
ventilation to ensure reliable operation of the This product is for general household purposes. Any
product, and to protect it from overheating. To failure due to use for other than household purposes
prevent fire hazard, the openings should never be (such as long-term use for business purposes in a
blocked or covered with items (such as newspapers, restaurant or use in a car or ship) and which
table-cloths, curtains) or by operating the requires repair will be charged for even during the
equipment on thick carpet or a bed.D3-4-2-1-7b_A_Enwarranty period. K041_En
POWER-CORD CAUTION
If the AC plug of this unit does not match the AC Handle the power cord by the plug. Do not pull out the
outlet you want to use, the plug must be removed plug by tugging the cord and never touch the power
and appropriate one fitted. Replacement and cord when your hands are wet as this could cause a
mounting of an AC plug on the power supply cord of short circuit or electric shock. Do not place the unit, a
this unit should be performed only by qualified piece of furniture, etc., on the power cord, or pinch the
service personnel. If connected to an AC outlet, the cord. Never make a knot in the cord or tie it with other
cut-off plug can cause severe electrical shock. Make cords. The power cords should be routed such that they
sure it is properly disposed of after removal.are not likely to be stepped on. A damaged power cord
The equipment should be disconnected by removing can cause a fire or give you an electrical shock. Check
the mains plug from the wall socket when left the power cord once in a while. When you find it
unused for a long period of time (for example, when damaged, ask your nearest PIONEER authorized
on vacation). D3-4-2-2-1a_A_Enservice center or your dealer for a replacement.S002_En
Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified
service personnel.
IMPORTANT: THE MOULDED PLUG
This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug. Should the
fuse need to be replaced, please ensure that the replacement fuse has a rating of 5 amps and that it is approved by ASTA or BSI to BS1362.
Check for the ASTA mark or the BSI mark on the body of the fuse.
If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug
must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer.
If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of
safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.
If a new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician.
WARNING : THIS APPARATUS MUST BE EARTHED.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
Green & Yellow : Earth Blue : Neutral Brown : Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows ;
The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked with the letter E or
by the earth symbol or coloured GREEN or GREEN-AND-YELLOW.
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letterN or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letterL or coloured RED.
How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.
D3-4-2-1-2-1_B_En |
ACEC
PIONEER
