DVR-230_UK.book Page 23 Friday, July 1, 2005 11:52 AM
Getting started04
Channel presets are numbered 1-99. Note
If the recorder is connected to your TV using a SCART
cable and your TV supports Direct Recording, it?s Channel presets are numbered 1-99.
possible to quickly start recording whatever channel
your TV is tuned to. See Direct recording from TV on Changing audio channels
page 38 for detailed instructions.You can change the audio channel of the broadcast or
5 Press REC to start recording.external input signal.
By default, the recording will be in SP (standard play)
mode, which will give you around two hours of
recording from a blank DVD disc. The different AUDIO
recording mode and their recommended uses are
covered in mode detail in Chapter 6.
You can pause recording by pressing
.
Press REC or
again to restart recording.
Y Press AUDIO to change the audio.
6 When you want to stop recording, press .The current audio channel is displayed on-screen.
If the NICAM audio setting (see Audio In on page 56)
Playing back your recordingis set to NICAM and you are watching a NICAM
The TV program you just recorded should be on the DVD broadcast, you can switch between NICAM and
disc as a single title with one or more chapters.Regular (non-NICAM) audio.
Y Press to start playback.NICAM
If you want to stop playback before the end of the Regular
recording, press .
If the NICAM broadcast is bilingual, you can also
select the language.
Using the built-in TV tunerNICAM ANICAM B
RegularNICAM A+B
Changing TV channels
There are three different ways to select TV channels. Note You can also select the language for a non-NICAM
that you can?t change the TV channel during playback, bilingual broadcast.
recording or during recording standby.
A (L)B (R)
A + B (L+R)
123 When watching a recording made from an external
input with Bilingual recording selected (see Audio In
on page 56), you can switch the audio channel 456
7890between left (L), right (R) or both (L+R).
LR
CH+
L+R
ENTER
NoteCH-
When recording in Video mode, or in VR mode using
the XP setting, only one channel of a bilingual
CH +/� buttons on the remotebroadcast is recorded. In this case, decide which
Number buttons on the remote - For example, to language you want to record before recording by
select channel 4, press 4 then ENTER; for channel 34, setting the Bilingual Recording setting (see Audio In
press 3, 4, ENTER. (If you don?t press ENTER, the on page 56).
channel changes after a few seconds.)
+/� buttons on the front panel
23
En |
ACEC
PIONEER
