1234
(5) OSD FILTER SETTING (SUB screen 4)
ADepending on the monitor used, the character flicker on the OSD may stand out.[Purpose]
If a system, such as charavter flicker, appears on the monitor, select the filter response.
[Tools to be used]
Remote control unit for servicing
B(GGF1381)
[How to enter]Y While the User Operation screen is displayed, press the then keys, then theESCDISPDIG/ANA
key four times, in that order.
Y While subscreen 3 of the first screen is displayed, press the key.DIG/ANA
[How to quit]Press the key.ESC
[Setting procedures]
COSD Filter Setting
OSD FILTER : 4 1 Display subscreen 4.
2 Select the setting from the key operation table.
Subscreen 4
[Tips]
As the setting value becomes greater, jitter is reduced on a CRT display. However, as lines for characters appear thick, complex
characters may become difficult to read. On the contrary, as the setting value becomes smaller, jitter increases on a CRT display.
However, as lines for characters become sharper, complex characters become more legible.
D
Note: Use the remote control unit for servicing.
Note: A new setting becomes active as soon as it is made. As a new setting is stored in nonvolatile memory, it will be retrieved
when the unit it turned on the next time.
Note: After the factory-preset values are downloaded, the setting value for the OSD Filter will be the default value (4).
[(Table 2) Key operation of OSD Filter setting]
KeyOperationSetting valueRemarks
[ Rev x 3 ], [SPEED+]
[ Rev x 3 ], [SPEED+] Changing the setting value for the 0 - 4 (Default value: 4) : The setting value increases by 1.
[ x 3 Fwd], [SPEED-][ x 3 Fwd ], [SPEED-]OSD Filter
E
: The setting value decreases by 1.
[CLEAR]The setting value is reset to default.�
[ESC]To exit the OSD Filter Setting and
clear the screen (Appears the tuner ��
screen.)
F
DVR-RT602H-S124
1234 |
ACEC
PIONEER
