Setup Relating to Operations From the Control Panel
(OPERATION Menu)
j) Settings for manipulating the snapshot attributes in the Flexipad
section
This changes the method of operation of the EFF DISS button and the
AUTO TRANS button in the Flexipad for each M/E bank, for
manipulating the snapshot attributes.
MODE1: This is used when saving snapshot attributes. The attributes
of the button which is lit are applied to the register.
MODE2: This is used when recalling snapshot attributes. When a
register is recalled, the snapshot is recalled according to the
attributes of the button which is lit. When a register is recalled
when the button is not lit, the snapshot is recalled with the
attributes attached to the register.
To carry out these settings, use the following procedure.
1In the OPERATION menu, press F5 (OPERAT MODE).
The OPERATION MODE menu appears.
BUSDSK AUTOXPTSHIFTKFCUSTOMPROGRAM
TOGGLEDROPSHIFTLOCKMODEMODEBUTTON
ONRIGHTOFF
F1F2F3F4F5F6F7F8F9F10
Function key indications in the OPERATION MODE menu
2Carry out the operation in the following table to make the required
setting.
SettingOperation
Setting thePress F1 (BUS TOGGLE).
background transitionThis toggles the setting between ON and OFF.
flip-flop mode
Setting theCarry out the following procedure.
downstream keyer1Press F2 (DSK AUTO DROP).
auto drop functionThe DSK AUTO DROP menu appears.
2Press one of F1 (DSK1) to F4 (DSK4) according to the
downstream keyer to which the setting applies.
Pressing the button toggles the auto drop function on
and off.
Setting the cross-Press F3 (XPT SHIFT).
point button shiftThis cycles the setting through OFF, RIGHT and LEFT.
function
(Continued)
14-80Chapter 14Setup |
ACEC
SONY
