To adjust the audio output level of theSelecting the display range of the audio
MONITOR OUTPUT connectorslevel meters
You can make an initial settings to allow the audio
output level of the MONITOR OUTPUT connector toYou can switch the range of audio level meters display
be adjusted with the PHONES level control on theby pressing the DISPLAY FULL/FINE button on the
upper control panel.
upper control panel.
For details, refer to O1-9. SWITCH SETTINGS ON THEFULL mode: The meter range is �60 to 0 dB or �40
CONNECTOR PANEL AND BOARDS� in the Installationto +20 dB.
and Maintenance Manual.FINE mode: The meter scale is enlarged, and the
signal level is indicated in 0.25 dB steps, with the
reference marker indicated by a lit LED in the
5-1-3 Adjusting the Audiomiddle of each meter.
Recording Level
This specification can also be done by setting 806.
LEVEL METER SCALE in the VTR SETUP menu.
Adjusting the recording level
Recording with the reference level
If the REC level controls on the upper control panel
Chapter 5 Recording/Playback
are pushed in, audio signals are recorded at the
reference level (0 dB reference level indicated in the
audio level meters for +4 dBm input).
Recording with the specific recording levelDISPLAY FULL/FINE button
Pull out the REC level controls for the appropriate
channels and rotate them so that the audio level meters
indicate approximately 0 dB for the average audio
signal input level.Selecting the display range of the audio level meters
REC level controls
Adjusting the recording level
Chapter 5 Recording/Playback5-3 |
ACEC
SONY
