The remote control
Insert the batteryRemote control setup
When using two camera-recorders simultaneously,
1Push the catch in the direction shown by arrow
set this camera-recorder and the remote control to
(1) to remove the holder.
either [VCR1] or [VCR2] so the remote control does
not operate the wrong camera-recorder by mistake.
Setting
? Wireless remote control
Press the STOP (g) and STILL ADV () buttons
at the same time to set the remote control unit for
2Insert the battery with the ?+? marked side use with VCR1.
facing up.Alternatively, press the STOP (g) and STILL ADV
() buttons at the same time to set the remote
control unit for use with VCR2.
When the battery in the remote control unit is
replaced, the remote control unit is set for use
with VCR1.
?Camera
In the setup menus, OTHER FUNCTIONS
screen, REMOTE, set to VCR1 or VCR2.
3Return the holder to its original position.
(Page 76)
If different settings are used for the camera-
recorder and remote control unit, ?REMOTE? lights
in red on the viewfinder and LCD monitor.
? When the battery (CR2025) has run out, replace it
with a new one. (The battery lasts about one year, START/
DATE/PHOTOSTOP
OSDTIMESHOT
depending on the frequency of use.)
If the remote control unit fails to work even when it COUNTER RESET TITLEZOOM
is operated near the camera-recorder?s remote MULTI/P-IN-PREC A.DUB
VOL+-
control sensor, the battery has run out./REW PLAYFF/
? Keep the battery out of the reach of children.
STILL ADV PAUSE STILL ADV
INDEXSTOP INDEX
VCR2VCR1
SELECTVAR.PB.
SEARCHZOOM
STORE
MENU
OFF/ONSET
P.B.DIGITALITEM
E-19 |
ACEC
PANASONIC
