CONVERGENCE ADJUSTMENT
Adjust convergence from center to circumference in order.
1. Select the adjustment mode following the steps on page 11.
RCUT
40H
KEY FUNCTION IN THE
CONVERGENCE ADJUSTMENT:
GENERAL ADJUSTMENTSUp :2 button
Selet Green color:3 button
Left :4 button
Blinking of cursor ON/OFF: 5 button 2. Press O7� button to display the built-in cross-hatch pattern.
Right:6 button
Adjust mode ON/OFF:7 button
Down:8 button
Erase Green line:0 buttonCursor
Erase Red line:100 button
Erase Blue line:ENT button
X: I
Y: I
FULLC: R
FULL
SPECIFIC INFORMATIONS
3. Press PIC-SIZE button to select the FULL mode.
FULLWIDE1WIDE2
Note:
Adjusting procedure in replacing conver-The pattern includes three colors (R, G, B).
gence board.The cursor should be blinking in Red.
1. User convergence center check. MakeThis means that the Red color is adjustable.
sure the best convergence setting isAdjustment around cursor can be done.
about the center of adjustable range4..Press O3� button to select Green color to be adjusted.
2. CENTERING ADJUSTMENT5. Press O5� button to stop the blinking of cursor.
3. PICTURE POSITION ADJUSTMENT6. Press O2 (up)�, O8 (down)�, O4 (left)� or O6 (right)� to obtain the correct
4. HIT, WID ADJUSTMENTcross-hatch pattern as above.
5. CONVERGENCE ADJUSTMENTIf necessary, the specified color line can be erased from the screen.
100 button .................. to erase Red line
0 button .................. to erase Green line
ENT button .................. to erase Blue line
7. Press O5� button to make the cursor blinking.
8. Press O2�, O8�, O4�, O6� buttons to move the cursor to other point to be
adjusted.
9. Repeat steps 5 to 8.
10. Repeat steps 4 to 9 to adjust Red and Blue colors.
Converge the selected color line into the Green line.
11. Press O7� button to enter the adjusted states.
At this time, picture changes for about 1 second.
12. Repeat steps 3 to 12 for WIDE mode.
13. Press O7� button again to return to the normal picture.
� 18 � |
ACEC
TOSHIBA
