Using your appliance
The cutlery basket is in two
Loading your appliance
parts which can be separated
Before placing dishes in the machine, remove any scraps of
to give greater loading
food, to avoid clogging the filters and consequently reducing
flexibility.
the performance.
To separate the two parts,
Do not load very small items which can fall through the
slide them horizontally in
baskets.
opposite directions and pull
them apart.
The lower basketTo reassemble, reverse the
procedure.UI62
The lower basket is designed to take saucepans, lids, plates,
salad bowls, cutlery etc.
Serving dishes and large lids should be arranged around the
The upper basket
edge of the basket, ensuring that the upper spray arm can turn
The upper basket is
freely.
designed for plates (dessert
plates, saucers, dinner plates
of up to 25 cm in diameter),
salad bowls, cups and
glasses.
Arrange items on and
underneath the cup racks so
that water can reach all
surfaces. US64
Light items (plastic bowls
UI21etc.) should be loaded in the upper basket and arranged soUI48
they do not move.
The two rear rows of prongs on the lower basket can be easily
lowered to allow you to load pots, pans and bowls.Before closing the door, ensure that the spray arms can
rotate freely.
To lower the prongs:
- Slightly pull them upward and let them drop down (see
In case that plates are loaded in the upper
picture).
basket:
- To bring them back to the standing position, just pull them up
load them starting from the
again.
rear positions of the basket,
tilting them forwards and
avoiding the front positions
near the door.
US71
Adjusting the height of the upper basket
If washing very large plates (over 27 cm and up to 32 cm in
UI85
UI18
diameter) you can load them in the lower basket after moving
the upper basket to the higher position.
The cutlery basketTo move to the higher position proceed as follows:
1.Move the front runner
Long bladed knives stored in an upright position are a
stops (A) of the upper
potential hazard.
basket outwards and slide
Long and/or sharp items of cutlery such as carving knives
the basket out.
must be positioned horizontally in the upper basket.
Take care when loading or unloading sharp items such as2.Refit the basket in the
knives.higher position and
replace the stops (A) in
Cutlery should be placed in the removable cutlery basket with
their original position.
the handles facing downwards.
If the handles protrude from the bottom of the basket,
When the top basket is inRC01
obstructing the lower spray arm, load the cutlery with the
the higher position it will
handles facing upwards.
only take plates up to 20 cm in diameter and you will not
Mix spoons with other cutlery to prevent them from sticking
be able to use the raised cup racks.
together.
After loading your machine always close the door, as an
open door can be a hazard.
5 |
ACEC
ZANUSSI
